User manual ZERO88 LIGHTMASTER XL

[. . . ] Lightmaster XL Manual /p1/4 Lightmaster XL Manual Third Issue February 1995 Zero 88 Lighting Ltd reserves the right to make changes to the equipment described in this manual without prior notice. This equipment is designed for professional stage lighting control and is unsuitable for any other purpose. It should be used by, or under the supervision of an appropriately qualified or trained person only. Software version 6116 Warning If a portable or temporary three phase mains supply is used to power this desk We recommend that the desk mains plug is removed before connecting or disconnecting the supply. [. . . ] Adding a Step to an existing Sequence 1 Set the Mode switch to Program. Ensure that all faders except for Grand Master are at 0. 2 Press the Effects Flash/Preview button once to select the Effects section. Press the Go button to select the Step No before the step to be inserted. 4 Press Add Step to insert a blank step after the step that was being displayed. 5 Set up the scene to be recorded on Preset A and set Master A to the level required. * Adding a Step to a Sequence (Continued) 6 Press Program. 7 Turn the Mode switch to Run, fade the Effects Master to full and Master A to 0 to view the resulting sequence. Deleting a Step in a Sequence or deleting an entire Sequence 1 Turn Mode switch to Program. Press the Effects Flash/Preview once to select the memory. 3 Select the sequence to be edited using the Sequence +/- buttons and the Step Number using the Go button. 4 Press Delete Step once to remove the step number that is displayed. P:ress and hold to delete the entire sequence. Clearing an Audio Memory 1 Turn Mode switch to Program. Press the Effects Flash/Preview once to select the memory. 3 Select the Audio Memory using the Sequence +/- button and the Step Number using the Go button. 4 Press Program once to program zero levels into the audio memory selected. 5 Repeat steps 3 and 4 for any other audio memories that need clearing. * * * * NOTES (Continued) * Page Overlay When changing from one sequence to the next, Page Overlay is in operation, so the Effects Master must be put down to 0 and then up again for the sequence change to take effect. Page Overlay in operation is shown by the Sequence display blinking slowly. If Fade Time is in use, the output must be 0 before the sequence will change. THIS IS IMPORTANT TO REMEMBER Effects Speed, Drive and Attack While an effect is running and the effect is shown in the Sequence display, Speed, Drive and Attack may be modified `live' as required. [. . . ] Super User set up options have been corrupted The output Strobe / Full Level channel memory has been corrupted The DMX patch memory has been corrupted Lost Pattern - The sequence memories have been corrupted The MIDI lighting control data has been corrupted All these problems are likely to be transitory. They may require a Super User Clear Memory and/or Reset operation and some reprogramming. Always keep a copy of important shows on a Memory Card. Hardware Problems The Lightmaster XL will display `CR' (crash) in the Page display if the hardware is not operating correctly. There are two types of crashes: those that will allow some desk operations to proceed despite the fault and those that prevent the desk working completely. Hardware Problems (Continued) When a hardware problem is detected the desk will stop but the outputs will stay at their previous levels. [. . . ]