User manual ZIBRO PX738

[. . . ] For safety reasons, please read this manual carefully before operating. Persons who are not familiar with this manual must not use this air conditioner. We strongly recommend keeping this manual in a safe place for future reference. Do Do Do Do Do Do not not not not not not use a damaged cable. [. . . ] The remote control is ready for use after the beep signal. 3 The following functions can be selected with the mode button remote control. Automatic regulation of ventilator speed Cooling; Dehumidifying Circulating COOLING When the cooling mode is activated, the transparent ring around the button on the front of the device · The following settings are possible in the cooling mode: The ventilator speed can be adjusted by pressing the Automatic regulation of ventilator speed High Medium Low The temperature can be set between 18°C and 32°C by pressing the buttons. Whether the desired temperature can actually be reached depends on the ambient conditions. The room temperature remaining above the set temperature is normal. DEHUMIDIFICATION When the dehumidification mode is activated, the transparent ring around the button on the front of the device · During the dehumidification, the ventilator speed speed is set automatically to medium. When the air circulation mode is selected, the transparent ring around the button on the front of the device · emits GREEN light. In this mode, the air is circulated and filtered but not cooled or dehumidified. In this mode, only the ventilator speed can be adjusted by pressing the -button: When the temperature in the room changes, the mode changes automatically in order to maintain the desired temperature as accurately as possible. the ventilator speed is also adjusted automatically. The colour of the transparent ring around the button on the front of the device · Negative ions are generated in every operating mode (automatic, cooling, dehumidification and circulation). By removing the rubber plug from the water drain ¸, the water will run out here. Water must always be able to flow freely. 4 ADJUSTING THE TIMER You can use the timer function to set in advance when the airconditioner is to switch on or off. Switching off The timer OFF function can be set when the airconditioner is switched on: · Press Set the number of hours desired (1-12) with the aid of Press and Switching on The timer ON function can be set when the airconditioner is switched off (stand-by): · Press Set the number of hours desired (1-12) with the aid of Press on the remote and When the Timer function has been set the light in the button on the front of the device will switch on. When the desired time has been set, press the to save the setting. -button again in order The light of the display fades when the remote control has not been used for some time. This is reactivated when you touch any button. The compressor has been set so that it starts functioning three minutes after the (re)start of the air conditioner. The compressor will be switched off when the room temperature is lower than the set temperature. operation is continued in the circulation mode. When the room temperature is higher than the set temperature, the compressor switches on again. [. . . ] DISCONNECTING 1 Switch off the unit, remove the plug from the mains and leave it idle for at least 30 minutes. 2 Open the cabinet cover for quick connector shielding µ. Terminals are fitted with automatic self-sealing valves to prevent the refrigerant from leaking. Loosen the nuts quickly, so the seal is made promptly. [. . . ]