User manual ZIBRO R 17

[. . . ] R 17 3 2 6 5 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING INSTRUCCIONES DE USO OPERATING INSTRUCTIONS ISTRUZIONI D'USO GEBRUIKSAANWIJZING 2 14 26 38 50 62 74 Dear Sir, Madam, Congratulations on your purchase of this Zibro heater, the number one brand amongst portable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your Zibro heater. [. . . ] 2 Pull the knurled wick adjustment knob off the heater, so the wick height lock will be visible. Q 3 Take the plastic collar between your thumb and index finger and pull it out. Turn the collar up one step, to either position 2 or 3 (Fig. Carefully push the collar back, so the pin engages in the recess. 4 Carefully reinstall the knurled wick adjustment knob. This can be done in one way only - check the rear of the cap for the correct position. If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). 4 55 If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If the flame gets too high after adjusting (Fig Q), the wick height lock should be placed one position lower again. Otherwise smoke or soot may be caused. G MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your dealer. F 4 56 THE HEATER DOES NOT IGNITE The batteries are not positioned correctly in the holder. There is not enough power left in the batteries for the ignition. You have run out of fuel from the tank or the wick has been replaced. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. You are pushing the ignition button with too much force. IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS The combustion chamber has not been positioned correctly. Use the handle to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. You are using fuel which is past its `use by' date. Start every heating season with fresh fuel. You are using the incorrect type of fuel. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Dust has gathered in the lower part of the heater. THE HEATER SLOWLY EXTINGUISHES The removable tank is empty. The fuel filter is contaminated by moist. The lower reservoir is contaminated by moist. The wick has hardened on the upper side. [. . . ] Ensure that you are wearing gloves and that you have a container in which to put the old wick. 11 4 60 12a 12b 12 Install the wick to the wick sleeve according to the allowed direction engraved on the wick sleeve. 13 Install the wick sleeve (with wick) to the primary air tube. And then install the top of the stem into the 13a 13b groove of the wick sleeve (with wick) from right side, and left the stem to the end. 14 Install the wick height lock (the wick position should be adjusted at No. [. . . ]