User manual ZIBRO RCA100

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro Kamin. Below you will find the main steps to be taken for using your Zibro Kamin. ² ¶ Ignite the heater using the key (refer to Section D). [. . . ] 5 Minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. F: When the CLOCK indicator light stops blinking, the setting has been locked to the indicated value. When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. Always ignite the heater with the lighter. Once the heater is burning, the The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. I: When the KEY-LOCK light lights up, the childproof lock has been activated. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. The KEY-LOCK indicator light will light up (Fig. i) , indicating that the childproof lock has been activated. Switch off the childproof lock by pressing the key and holding it down for more than 3 seconds once again. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. [. . . ] Some drops may leak from the filter; keep a cloth at hand. ) 3 Reinstall the fuel filter into the heater. We recommend that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. Do not remove any heater components yourself. [. . . ]