User manual ZIBRO RCA68

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro Kamin. Below you will find the main steps to be taken for using your Zibro Kamin. ² ¶ Ignite the heater using the key (refer to Section D). [. . . ] After approximately 10 seconds the blinking will stop and the setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. Always ignite the heater with the button . Once the heater is burning, the The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. The following will then appear in the display: . If desired, you can switch the heater on again by pressing (see Section D). When te heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. the display will show the autocleaningcode cl:05 running back to cl:00. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner I: When the KEY-LOCK light lights up, the childproof lock has been activated. When the burner is clean again, the heater will automatically switch back to the highest setting again. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. The KEY-LOCK indicator light will light up (Fig. [. . . ] L: A blinking VENT indicator light is a sign that you need extra ventilation. Switch off the heater and let it cool down, before you start any maintenance work. also disconnect the plug from the mains. Your Zibro Kamin needs hardly any maintenance. [. . . ]