User manual ZIBRO SRE 166

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in materials or workmanship. We wish you a warm and comfortable time with your heater. Yours sincerely, PVG International b. v. Customer Service Department 1 READ THE DIRECTIONS FOR USE FIRST. 2 IN CASE OF ANY DOUBT, CONTACT YOUR DEALER. 3 BEFORE YOU START READING, FOLD OUT THE LAST PAGE. 4 42 GENERAL DIRECTIONS FOR USE Below you will find the main steps to be taken for using your heater. For more details, please refer to the MANUAL (pages 45 ff. ). MAIN COMPONENTS Front plate Grid Base plate Lid for removable 1 2 3 4 5 Remove all packaging materials (refer to Section A, Fig. tank Fill the removable tank (refer to Section B, Fig. [. . . ] The information display Just press the indicating that the ignition procedure has started. Once the heater is burning, the will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). Prior to igniting the heater, always check for sufficient fuel in the removable tank. E SETTING THE REQUIRED TEMPERATURE The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to will start blinking). Next, adjust switch on the function (the C mark and 4-digit the temperature using the key on the right (Mmin. ) to set the temperature to a higher setting and the key on the left (Nhour) to lower the temperature. Press once to increase the value one step. After approximately 10 seconds the C mark and 4-digit will stop blinking and the setting will be locked (Fig. The display will show the autocleaningcode cl:05 running back to cl:01. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. I CHILDPROOF LOCK The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. The KEY-LOCK indicator ( Switch off the childproof lock by pressing the key than 3 seconds once again. ) will appear on the H: When the mark appears, the childproof lock has been activated. information display (Fig. H), indicating that the childproof lock has been activated. and holding it down for more J I: When the SAVE function is activated, the heater will automatically switch on or off in order to remain within a specified temperature range. THE CORRECT USE OF 'SAVE' The 'SAVE' function allows you to limit the temperature. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3C. [. . . ] In case they offer no solution, please take the heater to your dealer for repair. * Highly inflammable substances may induce uncontrollable burning, causing flames to break out. Should this happen, never try to move the heater, but always switch off the heater immediately. In case of emergency you may use a fire extinguisher, but only a type B extinguisher: a carbon dioxide or powder extinguisher. 10 TIPS FOR SAFE USE 1 2 150 cm 20 cm 50 cm 3 4 50 cm 150 cm 5 6 7 8 9 10 Make sure that children are always aware of the presence of a burning heater. Do not move the heater when it is burning or still hot. [. . . ]