User manual ZIBRO SRE147

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in materials or workmanship. We wish you a warm and comfortable time with your heater. Below you will find the main steps to be taken for using your heater. ² ¶ Ignite the heater using the key ¹ (refer to Section D). [. . . ] the information display ¸ will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to min. ) to set the temperature to a switch on the function (the °C mark and 4-digit ¸ will start blinking). Next, adjust the temperature using the key on the right ( Higher setting and the key on the left ( After approximately 10 seconds the °C mark and 4-digit will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. The KEY-LOCK indicator Switch off the childproof lock by pressing the key than 3 seconds once again. And holding it down for more When the FUEL indicator appears, there is enough fuel left for another 10 minutes of heater use. The count-down of the remaining heating time can be seen in the information display ¸ (Fig. J: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. If you do not react, the heater will extinguish by itself. The heater will also sound a warning signal, when it switches off. The FUEL indicator will blink, while four lines are blinking in the information display. You can stop this by pressing the button ¹ once. Once the heater has used up all its fuel and is extinguished it will take some time, after the refill, before the heater is completely ready for use again. When there is insufficient ventilation in the room, an intermittent buzzer will be heard (approximately once each ten minutes) and the VENT indicator will be lit. When this signal is given, ensure that the ventilation of the room is improved (e. [. . . ] The following provisions shall apply regarding this warranty: 3 The warranty shall no longer apply, when the heater has been modified, Non-original parts have been used, or when it is repaired by third parties. 4 The warranty shall not apply to parts that are subject to normal wear, such as 5 The warranty shall only apply, when you present the original, dated proof of Purchase, provided no changes have been made to it. 6 The warranty shall not apply to damages caused by actions not in compliance With the Directions for Use, neglect, and the use of an incorrect type of fuel, or fuel past its use-by date. The use of incorrect fuel can even be dangerous*. [. . . ]