User manual ZIBRO SRE151

[. . . ] Your heater comes with a 24-month manufacturer's warranty on all defects in materials or workmanship. We wish you a warm and comfortable time with your Zibro heater. Below you will find the main steps to be taken for using your heater. ² ¶ Ignite the heater using the key (refer to Section D). [. . . ] 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the standby position. When the heater has been unplugged (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. You should therefore provide extra ventilation. Always ignite the heater with the button . Once the heater is burning, the will show two numbers. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key down for more than 3 seconds. The KEY-LOCK indicator ( Switch off the childproof lock by pressing the key than 3 seconds once again. And holding it down for more I: When the SAVE function is activated, the heater will automatically switch on or off in order to remain within a specified temperature range. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Switch off the function by pressing the SAVE key once Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. [. . . ] It is, however, important that you clean the air filter ¾ and the vent filter µ with a vacuum cleaner and the grid with a damp cloth, both on a weekly basis. remove the air filter occasionally (Fig. Some drops may leak from the filter; keep a cloth at hand. 2 Remove the dirt by tapping the fuel filter upside-down against a hard surface. [. . . ]