User manual ZIBRO SRE157

[. . . ] Congratulations with your purchase of the Zibro Kamin, the number one brand among movable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro Kamin. [. . . ] The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to min. ) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( hour) to lower the After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key immediately after that. 2 Use the adjustment keys Use the key on the left ( to set the time at which the heater must ignite. Hour) to set the hours and the key on the right 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the button once to clear the timer setting. There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display ¹ not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: CODE INFORMATION Temperature within the heater too high. In case of any malfunctioning the information display will tell you what is the matter. [. . . ] It is, however, important that you clean the air filter cap grid and the vent filter with a vacuum cleaner and the with a damp cloth, both on a weekly basis. L: A blinking VENT indicator light is a sign that you need extra ventilation. Some drops may leak from the filter; keep a cloth at hand. ) 3 Reinstall the fuel filter into the heater. [. . . ]