User manual ZIBRO SRE910

[. . . ] Congratulations with your purchase of the Zibro Kamin, the number one brand among movable heaters. You have purchased a first-class quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro Kamin. [. . . ] The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. Use the adjustment keys to adjust the temperature. First press either of the two keys to MIN) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( HOUR) to lower the temperature. press once to increase the value one step. After approximately 10 seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged for more than 10 minutes (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the ON/OFF button and then the TIMER key immediately after that. To set the time at which the heater must ignite. HOUR) to set the hours and the key on the right Use the key on the left ( 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the ON/OFF button once to clear the timer setting. There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display ¹ not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. INFORMATION Temperature within the heater too high. H: In case of any malfunctioning the information display will tell you what is the matter. Always contact your Zibro Kamin dealer for any malfunctioning not listed above. [. . . ] It is, however, important that you clean the air filter cap grid and the vent filter with a vacuum cleaner and the with a damp cloth, both on a weekly basis. Some drops may leak from the filter; keep a cloth at hand. 2 Remove the dirt by tapping the fuel filter upside-down against a hard surface. ) 3 Reinstall the fuel filter into the heater. [. . . ]