User manual ZIBRO SS95

[. . . ] Congratulations on the purchase of your airconditioner. You have acquired a high quality product that, if used responsibly, will give you many years of pleasure. Please read these instructions for use first in order to ensure the maximum life span of your airconditioner. Customer service department Specifications Parts Before use Installation instructions Instructions for use Maintenance Protection Problem solving Guarantee conditions To be used as indication, subject to modifications. [. . . ] Connect the wires to the clamps on the terminal board in the following manner: 2. Place an approved circuit breaker between the power source and the unit for model S245. The air conditioner you have purchased may be a different model. Access cover for terminal board (inside) Outdoor unit Always connect the air conditioner to a separate power circuit. Refer to the diagram on the inside of the access cover for the connection of the wires. Note: All cables used must be approved in accordance with local regulations. Fit the drainage outlet and drainage hose (only for models with a heat pump). Condensation will drip off the outdoor unit when the indoor unit is operating in Heating mode. Fit a drainage outlet and a drainage hose in order to drain the water effectively. Fit the drainage outlet and rubber washer to the base plate of the outdoor unit (see fig. Installing and fitting the outdoor unit Bolt the unit to a level and solid base. Ensure that the unit is mounted securely in order to prevent problems caused by strong wind and vibrations. Close the pipes separately with the appropriate tightening moment. Air and moisture that remain in the pipe system after installation can damage the compressor. After the indoor and outdoor units have been connected, air and moisture must be removed with the aid of a vacuum pump (see below). Allow the vacuum pump to operate for 10-15 minutes until a pressure of 10 mmHg absolute is achieved. Close the low-pressure button on the vacuum pump while the pump is still operating. Open the two-way valve (1/4 turn), and close it again after 10 seconds. check all connections with liquid soap or an electronic leak detector. Turn the two-way and three-way valves to their operating positions. Note Read these instructions for use before commencing installation. make sure that no air remains in the cooling system and that no refrigerant is leaking. [. . . ] If this is the case, pull the plug out of the socket, and then reinsert it after 2-3 seconds. changing the mode during operation: 3 minute delay. Odour may be caused by another source ­ furniture, cigarettes, etc. the unit expels air that it has sucked in. [. . . ]