User manual ZYXEL NETATLAS ENTERPRISE QUICK START GUIDE V1.02

[. . . ] 4 Locate device(s) that you want the EMS to manage. 5 If required, configure the ODBC driver to connect to the database. 3 Installing the EMS Follow the steps below to install the EMS server on a computer. 1 Install SNMPc if it is not already installed. See the user's guide for more information. [. . . ] 5 Click Compile in the Compile Mibs screen. 6 Click Yes when asked to confirm, then click OK. 7 Finally click Done in the Compile Mibs screen. 6 Finding your Switch The SNMPc Network Manager can find new devices automatically using auto-discovery (enabled by default) or you will have to add device(s) manually. 6. 1 Device Auto-Discovery 1 To enable auto-discovery and then find your device, click Config, Discovery/Polling. 2 Select the Enable Discovery check box and click OK. 3 Find your device in the Device List panel. Double-click the device icon to access the EMS. 6 NetAtlas Enterprise Quick Start Guide 6. 2 Add Device(s) Manually If you have disabled auto-discovery, follow the steps below to add your device(s) manually. 2 In the MAP Object Properties screen, enter a descriptive device name and IP address for the device and then click OK. 7 Using SNMP Check that you are using SNMP Version 2c (SNMPv2c). If you are not using SNMPv2c, you must uninstall any previous versions and install SNMPv2c. Refer to RFC 1901 for more information on SNMPv2c. 1 Right-click the Device icon and select Properties. 3 Set the specified fields in the Map Object Properties screen exactly as shown in the figure. Note: For security purposes, it is strongly recommend to change the Read Community and Read/Write Community defaults. Write down this information in a secure place so you will not forget it later. 7 NetAtlas Enterprise Quick Start Guide 4 Click OK. After the device has been found, the icon and label appear in the network manager view window. 5 Right-click on the device icon to view a set of SNMPc network manager shortcuts. Click Properties to verify the information you entered in the previous step. 6 Make sure the PostgreSQL database is running. PostgreSQL should start automatically when you start Windows. If it does not, click Start (or start), Programs, PostgreSQL 8. 0 and then click Start service. 8 Accessing the EMS Follow the steps below to access the EMS. 1 In the SNMPc main screen, double-click the device icon to view the Switch Manager. Click the Switch Manager icon to access the main EMS configuration screen. 9 Troubleshooting 1 SNMPc, EMS and/or PostgreSQL will not install properly · Make sure that the computer on which you want to install the SNMPc, EMS and PostgreSQL meets the minimum hardware and software requirements. · To install PostgreSQL, make sure your computer is using NTFS file system. 8 NetAtlas Enterprise Quick Start Guide · Shut down any running services or applications which may affect the installation. · Remove any previous versions of PostgreSQL and SNMP software from your computer. [. . . ] You must configure the ODBC driver for the EMS to connect to the PostgreSQL database successfully. Follow the steps below to configure the ODBC driver in Windows 2000. Steps are similar for other supported Windows operating systems. 1 Click Start, Settings and Control Panel to open the Control Panel screen. [. . . ]