User manual ZYXEL PRESTIGE 660H QUICK GUIDE

[. . . ] After you've viewed the tutorial, click "Configuration Genie" at the end of the installation tutorial or from "Multimedia Auto Provisioner" in the CD. 2. 2 Zero Configuration Launch your web browser and navigate to any web site (for example, www. zyxel. com). The Prestige automatically detects and configures your Internet connection. If you have a PPPoE or PPPoA connection, a screen displays prompting you to enter your Internet account information. Enter the username, password and/or service name exactly as provided. [. . . ] Click Advanced Setup, Wireless LAN and then click OTIST. To change the Setup key enter up to eight printable characters. To have OTIST automatically generate a WPA-PSK key select the Yes check box. If you manually configured a WEP key or a WPA-PSK key and you also selected this check box, then the key you manually configured is used. Note: The AP and wireless client(s) MUST use the same Setup key. In each wireless client ZyXEL utility, click the Adapter tab. Select the OTIST check box, enter the same Setup Key as your Prestige's and click Save. Note: You must click Start in the Prestige OTIST web configurator screen and in the wireless client(s) Adapter screen all within three minutes (at the time or writing). You can start OTIST in the wireless clients and Prestige in any order but they must all be within range and with OTIST enabled. 9 Prestige 660H/HW Series Quick Start Guide 4 NAT NAT (Network Address Translation - NAT, RFC 1631) means the translation of an IP address in one network to a different IP address in another. For example, you could translate one public IP address to multiple private IP addresses on your LAN (SUA Only). Click Advanced Setup and then NAT to open the NAT-Mode screen. Select SUA Only if you have one public IP address and Full Feature if you have multiple public IP addresses (for address translation). Select Enable SIP ALG to allow VoIP calls to pass through NAT. If you have servers on your LAN, configure an SUA server set to have them visible to the outside. From the NAT - Mode screen click Edit Details and fill in the fields as shown. 5 Firewall The firewall is already enabled by default on the Prestige. Click Advanced Setup and then Firewall to open the firewall screen. The firewall protects your LAN from attacks from the Internet. No traffic can enter your LAN unless a request was generated on the LAN first. Click Default Policy to see rule direction information. You can also disable the firewall here if you want. 10 Prestige 660H/HW Series Quick Start Guide 6 Troubleshooting PROBLEM CORRECTIVE ACTION None of the LEDs turn on when Make sure that you have the correct power adaptor connected to the Prestige, it you connect the Prestige's is plugged into an appropriate power source and the Prestige is turned on. If the LEDs still do not turn on, you may have a hardware problem. In this case, you should contact your local vendor. Cannot access the Prestige from my computer. Check the cable connection from your computer to the Prestige. Make sure your computer's IP address is in the same subnet as the Prestige's IP address (see Section 6. 1 on page 11). [. . . ] In Windows 2000/NT, click Network and Dial-up Connections. 3 Right-click Local Area Connection and then click Properties. 11 Prestige 660H/HW Series Quick Start Guide 4 Select Internet Protocol (TCP/IP) (under the General tab in Windows XP) and click Properties. 5 The Internet Protocol TCP/IP Properties screen opens (the General tab in Windows XP). 6 Select the Obtain an IP address automatically and Obtain DNS server address automatically options. [. . . ]