User manual ZYXEL PRESTIGE 971M QUICK GUIDE V3.70

[. . . ] The CABLE LED blinks and turns steady on if the RF-Connector port is properly connected. The LAN LED turns on if the (corresponding) LAN port is properly connected. Table 1 Front Panel LEDs LED PWR SYS COLOR Green Green None LAN Green None USB Green None DATA Green None STATUS On Off On Blinking Off On Blinking Off On Blinking Off Blinking Off DESCRIPTION The power is on. The Prestige is receiving power and functioning properly. [. . . ] Enter the user name ("webadmin" is the default), and password ("1234" is the default) and click OK. Note: You should change your login information in the Security screen in the web configurator. 5 Prestige 971M Quick Start Guide 3 You should see this screen after a successful login. 3 USB Driver Installation Only install the USB driver if you wish to access the Internet by connecting to the P-971M via USB from a Windows computer. Note: At the time of writing the USB driver supports the following Windows operating systems. · Windows 98 Second Edition · Windows Millenium (Me) · Windows 2000 · Windows XP Connect the P-971M USB cable to your computer. If the Windows "found new hardware" installation wizard does not start, then try one of the following: · Disconnect the USB cable and connect it again. · Manually start the Windows "add new hardware" wizard. · Restart your computer and the P-971M. 6 Prestige 971M Quick Start Guide Note: The USB driver is on the included CD. Screens for other supported Windows operating systems may vary. Click Next to begin the wizard. Click Back to return to a previous screen or click Cancel to exit the wizard. 1 After you connect the USB cable, Windows should notify you that new hardware has been found. 2 Insert your CD into your computer CD-ROM and choose to have Windows search the CD for the drive. 3 Windows then installs the USB driver. If you see screens warning you about Windows logo compatibility or digital signatures not found, just continue. You may be prompted to restrat your computer depending on what operating system you are using. 7 Prestige 971M Quick Start Guide 4 Troubleshooting PROBLEM None of the LEDs light when you turn the power on. CORRECTIVE ACTION Make sure that you have the correct AC power adaptor connected to the Prestige, it is plugged into an appropriate power source and the Prestige is turned on. If the LEDs still do not turn on, you may have a hardware problem. In this case, you should contact your local vendor. Cannot access the Prestige web Check the cable connection from your computer to the Prestige. You must use Internet Explorer 6. 0 (or later), or Netscape Navigator 7. 0 (or The LAN LED is off. Make sure you enter the password correctly (the field is case sensitive). Check the condition of the coaxial cable connected to the back of the cable modem. If the cable looks to be in poor condition replace it. Check with your cable operator to ensure your Internet account has been activated. [. . . ] 3 Right-click Local Area Connection and then click Properties. 8 Prestige 971M Quick Start Guide 4 Select Internet Protocol (TCP/IP) (under the General tab in Win XP) and click Properties. 5 The Internet Protocol TCP/IP Properties screen opens (the General tab in Windows XP). 6 Select the Obtain an IP address automatically and Obtain DNS server address automatically options. [. . . ]