User manual 3COM H3C SECPATH F1000-A,SECPATH F1000-A HOST INSTALLATION GUIDE

[. . . ] H3C SecPath F1000-A Firewall Installation Manual Hangzhou H3C Technologies Co. , Ltd. http://www. h3c. com Manual Version: T2-08044H-20070622-C-1. 03 Copyright © 2006-2007, Hangzhou H3C Technologies Co. , Ltd. and its licensors All Rights Reserved No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of Hangzhou H3C Technologies Co. , Ltd. Trademarks H3C, , Aolynk, , H3Care, , TOP G, , IRF, NetPilot, Neocean, NeoVTL, SecPro, SecPoint, SecEngine, SecPath, Comware, Secware, Storware, NQA, VVG, V2G, VnG, PSPT, XGbus, N-Bus, TiGem, InnoVision and HUASAN are trademarks of Hangzhou H3C Technologies Co. , Ltd. All other trademarks that may be mentioned in this manual are the property of their respective owners. Notice The information in this document is subject to change without notice. [. . . ] Recommended power socket You are recommended to use a single-phase three-terminal socket with an earth contact, which must be properly grounded. The building ground system is often buried during the wiring engineering. Make sure that the building ground system is normal before connecting the AC power cord. III. Connecting an AC-input PSU Take the H3C SecPath F1000-A firewall for example. Step 1: Make sure that the grounding screw on the chassis is securely connected to the earth ground. Step 2: Make sure that the power switches are placed in the OFF position. Connect one end of an AC power cord provided with the device to the socket of AC-input PWR0 on the left-rear of the chassis and the other end to the AC mains supply. Step 3: Repeat Step 2 to connect the PWR1. (Skip this step if you use only one PSU. ) Step 4: Place the PWR0 switch into the ON position. Step 5: Place the PWR1 switch to the ON position. (Skip this step if you use only PWR0. ) Step 6: Check that the PWR0 and PWR1 LEDs on the front panel light. ON means the power connections are correct. Step 7: Check that the SYS LED on the front panel is ON. ON means the hardware system is working well. 3-9 Installation Manual H3C SecPath F1000-A Firewall Chapter 3 Hardware Installation 3. 7. 2 Connecting a DC-Input PSU I. DC-input PSU DC input power: ­ 60 VDC to ­ 48 VDC II. Connecting a DC-input PSU Take the H3C SecPath F1000-A firewall for example. Step 1: Make sure that the PGND is securely connected to the earth ground. Step 2: Make sure that the power switches are placed in the OFF position. Connect one end of a DC power cord provided with the device to the socket of DC-input PWR0 on the left-rear of the chassis and the other end to the ­ 48 VDC power source. Step 3: Repeat Step2 to connect the PWR1. (Skip this step if you use only one PSU. ) Caution: Before connecting a DC-input PSU, read the label on the power cord to be used to make sure that you are using a DC power cord. Step 4: Place the PWR0 switch into the ON position. Step 5: Place the PWR1 switch to the ON position. [. . . ] Its curvature radius must be equal to or greater than 10 cm. Ensure that the Tx and Rx ends are correctly connected. Ensure that the fiber ends are clean. Caution: Laser danger: never look into the optical ports that are connected to the laser. It can harm your eyes. Step 1: Insert the shipped SFP module into the corresponding slot. [. . . ]