User manual 3M BASECOATCLEARCOAT PAINT REPAIR

[. . . ] Use a mini orbital sander such as the 3MTM Nib Removal Sander 3125 and a 3MTM TrizactTM Finesse-itTM Film Disc Roll 466LA grade A5 to level/remove the defect. Use water to keep the abrasive from loading during sanding. Tech Tip: For better abrasive life and finish, spray the disc before and after each sanded spot. [. . . ] Work the polish thoroughly into the pad by rubbing the pad onto a work piece (by hand). It should have an even coating of polish across the entire face of the pad. Apply a small drop ("chocolate chip size") of 3MTM Finesse-itTM Polish ­ Extra Fine to the repair area. Use the pad to spread the polish evenly over the spot. The Dynabuffer line air pressure needs to be set at 80-85 psi while the tool is running. Polish with a downward force not to exceed 5 lbs. This is enough force to compress the foam and make the "nubs" on the foam pad disappear. Use one hand to hold the tool and the other hand to steady the tool. Tech Tip: If the polish is being slung outside of the repair area, too much polish is being used or not enough downward force is being applied. Reduce the amount of polish being applied or slightly increase the downward force being applied. Stop the tool before removing it from the work surface. Buffing time should be 5-10 seconds if 466LA grade A5 was used in step 1. Tech Tip: Do not run the edge of the backup pad into sharp edges ­ the foam will separate from the support plate if damaged. Wipe the area clean with a Scotch-Brite® High Performance Cloth ­ White. If sand scratches are not removed, re-polish as needed. Related Tools Machine Sanding: 3MTM Nib Removal Sander 3125 Machine Polishing: Dynabrade® Dynabuffer 3" Model #57126 Market: Metal Fabrication and Automotive OEM Application Description: Basecoat/Clearcoat Paint Repair page 3 Accessories Machine Sanding: 3MTM Finesse-itTM Disc Pad, Soft -- for 3MTM Nib Removal Sander 3125, PN 3125P (UPC 051111-60537-0) 3MTM Finesse-itTM Disc Hand Sanding Pad, Soft Contoured, PN 70437 (UPC 051135-92499-0) 3MTM Finesse-itTM Disc Hand Pad, Soft, PN 50199 (UPC 051111-50199-3) Machine Polishing: 3MTM HookitTM Disc Pad, 3" x 1/2" x 5/16"-24 EXT, PN 02700 (UPC 051111-55764-8) 3MTM Finesse-itTM Buffing Pad, Orange Foam, PN 02637 (UPC 051111-51158-9) Safety Information Always read and follow all safety information included with the product. Do not exceed maximum operating RPM's. [. . . ] 3M MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR ANY IMPLIED WARRANTY ARISING OUT OF A COURSE OF DEALING, CUSTOM OR USAGE OF TRADE. User is responsible for determining whether the 3M product is fit for a particular purpose and suitable for user's application. If the 3M product is defective within the warranty period, your exclusive remedy and 3M's and seller's sole obligation will be, at 3M's option, to replace the product or refund the purchase price. [. . . ]