User manual 3R SYSTEM ESPRIT

[. . . ] • Do not allow your headset to be submerged in water. • Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives. • If cleaning is required use a soft cloth, if necessary dampened with a minimum amount of water or diluted mild soap, to clean the product. About operating and storage temperatures • Do not operate or store in a place where temperature is below -15ºC (5ºF) or above 55ºC (131ºF) as this may shorten your battery life. [. . . ] Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. If there is no collection/recycling system for electronic products in your country, you can protect the environment by removing and recycling the battery before disposing the headset. 1 2 3 4 Notice for the European Union Hereby, Philips Consumer Lifestyle, BG Accessories, declares that this Philips Bluetooth stereo headset ESPRIT is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Battery disposal Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed of with normal household waste. Please inform yourself about the local rules on separate collection of batteries. The correct disposal of batteries helps prevent potentially negative consequences on the environment and human health. Notice for USA (FCC) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. EN 5 English Disposal of your old product Remove the integrated battery These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Relocate the receiving antenna. • Increase the separation between equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. A successful pairing establishes a unique encrypted link between the headset and the mobile phone. The headset stores the last eight links in the memory. If you try to pair more than eight devices, the link for the earliest paired devices is replaced by the new link. Select Back Select Back Select Back 1 2 Make sure that the mobile phone is turned on and its Bluetooth feature is activated. Make sure that the headset is charged and turned off. EN 9 English 3 Get started 3 Press and hold until the LED starts flashing white and blue alternately. »» The headset is in pairing mode, which lasts five minutes. 4 Use the headset Connect the headset to a mobile phone 1 2 Turn on your mobile phone. »» The headset is reconnected to the last connected device automatically. If the last one is not available, the headset tries to reconnect to the second last connected device. Tip •• If you turn on the mobile phone or its Bluetooth feature after turning on the headset, connect the headset from the Bluetooth menu on your mobile phone. Turn the headset off. (This function is available if your mobile phone supports this feature. ) Adjust volume. Activate voice dialing Press and hold for more than 4 seconds Press Press Press and hold Press twice Press twice Press and hold for more than 4 seconds - 1 long beep - 1 long white flash 1 short beep 1 short beep 1 short beep 1 short beep 1 long beep 1 long beep Automatic power saving If the headset fails to connect any Bluetooth device within range in five minutes, it powers down automatically to save the battery life. Slide up/ down VOL +/Press Press twice Press 1 short beep 1 short beep 1 short beep 1 short beep / 2 short beeps 2 short beeps before dial tone Use your headset Task Turn the headset on. Operation Sound or LED Indicator Press and 1 short beep hold for - 3 white more than 4 flashes: Battery seconds low < 25% - 2 white flashes: Battery level < 50% - 1 blue flash: Battery level > 50% Press twice Other status and indicators Headset Status The headset is connected to a Bluetooth device, while the headset is in standby mode or while you are listening to music. Indicator Blue LED flashes every 8 seconds. 10 EN The headset is on but not connected to a Bluetooth device. [. . . ] Battery is fully charged. Caution •• Finish your call before connecting the audio cable, as this will switch off battery power and end an incoming call. Blue LED flashes twice per second. White LED is off. Connect the supplied audio cable to • the headset and; • an external audio device. Wear your headset Adjust the headband for the best fit. Tip •• After use, twist both earshells, fold the headset flat for storage. Use with the audio cable With the supplied audio cable, you can use the headset with non-Bluetooth enabled devices or use the headset on airplane. No battery power EN 11 English The headset is ready for pairing. LED flashes whiteand bluealternately. Blue LED flashes fast. is required when you use the headset with the audio cable. 5 Technical data • • • • • • Up to 9 hours of play time or talk time Up to 200 hours of standby time Normal time for a full charge: 3 hours Rechargeable Lithium-Polymer battery (230 mAh) 3. 5 mm audio socket for corded headset mode Bluetooth 2. 1+EDR, Bluetooth mono support (Headset Profile - HSP, HandsFree Profile - HFP), Bluetooth stereo supported (Advanced Audio Distribution Profile - A2DP; Audio Video Remote Control Profile - AVRCP) Operating range: Up to 15 meters (50 feet) Adjustable, flat-folding headband Noise isolating slow recovery foam Digital echo & noise reduction Auto power off Battery status check • • • • • •   12 EN 6 Frequently asked questions Bluetooth headset does not switch on. Battery is low. [. . . ]