User manual 3R SYSTEM R2XX

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. del 30-06-12 Rev. 04 The manufacturer reserves the right to make changes without prior notice. www. philips. com/saeco 02 EN Register your product and get support at www. philips. com/welcome English 02 Type HD8838 SUP 037DRJ OPERATING INSTRUCTIONS 02 EN READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE MACHINE. IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. To protect against fire, electric shock and injury to persons do not immerse cord, plugs, or appliance in water or other liquid. [. . . ] • Lift the pre-ground coffee compartment cover. Green • 11 • CAPPUCCINO Danger of scalding!Brewing may be preceded by small jets of hot water. Important note: Immediately after using the machine to brew a cappuccino, clean all components as described in the "Cleaning of the Milk Brewing System" section. Before brewing coffee check the lights on the display and make sure the water tank and coffee bean hopper are full. It is possible to prepare a cappuccino with pre-ground coffee. Select the function with the “ ” button and pour the coffee in the compartment as described in the proper section. Place the cup you use every day to enjoy your cappuccino. After filling the milk container, place it in the machine. Make sure the container is inserted up to its limit. Green HOT MILK BREWING Danger of scalding!Brewing may be preceded by small jets of hot water. After filling the milk container, place it in the machine. Make sure the container is inserted up to its limit. • Before dispensing hot water, check that the following icon is displayed: Green To reset the machine to normal operation turn the selector switch counterclockwise until it is set to the “ ” position. When the machine is ready, proceed as follows: • Place a container under the dispensing spout. Orange It may happen that, even though the selector switch has been turned, hot water does not come out and the following icon is displayed. Wait for the warm-up phase to end in order to obtain a flow of hot water from the dispensing spout. • Turn the selector switch clockwise and set it to the “ position. Orange If the following icon is displayed, clean the dispensing spout. After placing an empty container press the “ ” button and wait until the dispensing is finished. Then, hot water may be dispensed. • The following icon will be displayed. Green Press the “ ” button to start dispensing hot water. • Pour the desired amount of hot water. To stop the hot water dispensing press the “ ” button. Green • 18 • ADJUSTMENTS The machine that you have bought allows for certain adjustments that will permit you to use it to its full potential. any type of operation inside the coffee bean hopper. Do not pour coffee beans when the coffee grinder is working. The machine allows slight adjustments to the coffee grinder to adapt it to the kind of coffee used. To make any adjustment, press and turn the knob inside the coffee bean hopper. Press and turn the knob by one notch at a time and brew 2-3 cups of coffee; this is the only way to notice differences in grind. The reference marks inside the coffee bean hopper indicate the grind setting. [. . . ] Press the “ ” button to start the manual priming cycle of the water circuit. The alarm is deactivated only if it is "RESET" in the programming mode. Orange TECHNICAL SPECIFICATIONS The manufacturer reserves the right to make changes to the technical specifications of the product. Nominal Voltage - Power Rating - Power Supply . See label on the inside of the service door Housing material . . Thermoplastic Material/Metal Size (w x h x d) (mm) . [. . . ]