User manual ABIT IN9 32X

[. . . ] About this Manual: This user's manual contains all the information you may need for setting up this motherboard. To read the user's manual of PDF format (readable by Adobe Reader), place the "Driver & Utility CD" into the CD-ROM drive in your system. Copyright and Warranty Notice The information in this document is subject to change without notice and does not represent a commitment on part of the vendor, who assumes no liability or responsibility for any errors that may appear in this manual. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular part of this document. [. . . ] These items set the high and low temperature limit that you want to do the fan speed control. These items set the high and low limit of PWM duty cycle that you want to provide the fan with. These items set the high and low voltage limit that you want to provide the fan with. The value of high limit must be set above the one of low limit. Click <Enter> key to enter its submenu (2nd FanEQ Group): AUX2~AUX4 FanEQ Control When set to [Enabled], these items control the AUX2~AUX4 fan speed by the following setting combinations. This item selects the reference point for taking temperature among the available options of CPU, SYS, and PWM Temperature, but there is only one "CPU Temperature" item to choose for the "CPU FanEQ Control". These items set the high and low temperature limit that you want to do the fan speed control. These items set the high and low voltage limit that you want to provide the fan with. The value of high limit must be set above the one of low limit. Click <Enter> key to enter its submenu: IDE Channel 1 Master/Slave, SATA Channel 1~6 When set to [Auto], the BIOS will automatically check what kind of IDE or SATA hard drive you are using. If you want to define your own drive yourself, set it to [Manual] and make sure you fully understand the meaning of the parameters. Leave this item at its default [Auto] setting to detect the access mode of your HDD automatically. capacity This item displays the approximate capacity of the disk drive. Usually the size is slightly greater than the size of a formatted disk given by a disk-checking program. cylinder This item configures the numbers of cylinders. Head This item configures the numbers of read/write heads. Precomp This item displays the number of cylinders at which to change the write timing. Floppy 3 Mode Support This item allows you to use "3 Mode Floppy Drive" in Japanese computer systems by selecting drive A, B, or both. Leave this item at its default [Disabled] setting if you are not using this Japanese standard floppy drive. Halt On This item determines whether the system stops if an error is detected during system boot-up. [All Errors]: The system-boot will stop whenever the BIOS detect a non-fatal error. [No Errors]: The system-boot will not stop for any error detected. [. . . ] A: To fill in this "Technical Support Form", please refer to the following instructions: · First name: Type in your first name. Subject: Type in the model name and the problem of your motherboard. Example 1: AA8XE and SCSI 29160 malfunction Example 2: AA8XE boot fails, POST code AF Example 3: AA8XE (system hang when S3 resume) Motherboard: Type in the model name and revision number of your motherboard. (You can find it on the screen during the POST sequence. [. . . ]