User manual ABIT KR7A-133R

[. . . ] Copyright and Warranty Notice The information in this document is subject to change without notice and does not represent a commitment on part of the vendor, who assumes no liability or responsibility for any errors that may appear in this manual. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular part of this document. In no event shall the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising from any defect or error in this manual or product. Product names appearing in this manual are for identification purpose only and trademarks and product names or brand names appearing in this document are the property of their respective owners. [. . . ] Integrated Peripherals In this menu, you can change the onboard I/O device, I/O port address and other hardware settings. Figure 3-6A. Integrated Peripherals Menu Default Screen VIA OnChip IDE Device: This item can let you sets several items concerning the VIA OnChip IDE device parameters. Figure 3-6B. VIA OnChip IDE Device Screen KR7A-133/KR7A-133R Introducing the BIOS 3-21 IDE Prefetch Mode: Two options are available: Disabled or Enabled. The onboard IDE drive interfaces supports IDE prefetching for faster drive accesses. If you install a primary and/or secondary add-in IDE interface, set this field to Disabled if the interface does not support prefetching. Onboard IDE-1 Controller: The onboard IDE 1 controller can be set as Enabled or Disabled. " Master Drive PIO Mode: !Auto: The BIOS can auto-detect the transfer mode of the IDE devices in order to set its data transfer rate (Default). You can select the PIO mode from 0 to 4 of the IDE devices in order to set its data transfer rate. " Slave Drive PIO Mode: !Auto: The BIOS can auto-detect the transfer mode of the IDE devices in order to set its data transfer rate (Default). You can select the PIO mode from 0 to 4 of the IDE devices in order to set its data transfer rate. " Master Drive Ultra DMA: Ultra DMA is a DMA data transfer protocol that utilizes ATA commands and the ATA bus to allow DMA commands to transfer data at a maximum burst rate of 100 MB/sec. !Disabled: If you encounter the problem of using Ultra DMA devices, you can try to set this item to Disabled. !Auto: When you select Auto, the system automatically determines the optimal data transfer rate for each IDE device. (Default) " Slave Drive Ultra DMA: !Disabled: If you encounter the problem of using Ultra DMA devices, you can try to set this item to Disabled. !Auto: When you select Auto, the system automatically determines the optimal data transfer rate for each IDE device. (Default) Onboard IDE-2 Controller: The onboard IDE 2 controller can be set as Enabled or Disabled. Description is the same as the item "Onboard IDE-1 Controller". PIO MODE 0~4 reflects the IDE device data transfer rate. The higher the MODE value is, the better the IDE device data transfer rate. However, it does not mean that the highest MODE value can be selected. You first have to be sure that your IDE device supports this MODE. Otherwise, the hard disk will not be able to operate normally. User's Manual 3-22 Chapter 3 Super IO Device: This item can let you sets several items concerning the Super I/O device parameters. Figure 3-6C. Super IO Device Screen Onboard FDD Controller: Two options are available: Disabled or Enabled. This is used to enable or disable the Onboard FDD Controller. If you add a higher performance controller, you will need to Disable this feature. [. . . ] If you feel that you need to contact ABIT directly you can send email to the ABIT technical support department. First, please contact the support team for the branch office closest to you. They will be more familiar with local conditions and problems and will have better insight as to which resellers offer what products and services. Due to the huge number of emails coming in every day and other reasons, such as the time required for problem reproduction, we will not be able to reply to every email. [. . . ]