User manual ABIT VT7

[. . . ] VT7 Socket 478 System Board User's Manual 4200-0387-02 Rev. 1. 00 Copyright and Warranty Notice The information in this document is subject to change without notice and does not represent a commitment on part of the vendor, who assumes no liability or responsibility for any errors that may appear in this manual. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular part of this document. In no event shall the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising from any defect or error in this manual or product. [. . . ] Boot Up Floppy Seek: When set to [Enabled], the BIOS will check whether the floppy disk drive is installed or not. Boot Up NumLock Status: This item determines the default state of the numeric keypad at system booting up. [On]: The numeric keypad functions as number keys. [Off]: The numeric keypad functions as arrow keys. Security Option: This item determines when the system will prompt for password - every time the system boots or only when enters the BIOS setup. [Setup]: The password is required only when accessing the BIOS Setup. [System]: The password is required each time the computer boots up. If you forget the password, you will have to open the computer case and clear all information in the CMOS before you can start up the system. But by doing this, you will have to reset all previously set options. APIC Mode: Leave this item to its default setting. MPS Version Control For OS: This item specifies which version of MPS (Multi-Processor Specification) this motherboard will use. OS Select For DRAM > 64MB: This item allows you to access the memory that is over 64MB in OS/2. Leave this item to its default [Non-OS2] setting for operating system other than OS/2. Report No FDD For WIN 95: When set to [Enabled], this item allows you to run some older operating system without floppy disk drive. Disable Unused PCI Clock: This option disables the clock of PCI slot that is not in use. [Yes]: The system automatically detect the unused DIMM and PCI slots, and stop sending clock signal to these unused PCI slots. [No]: The system always send clock signal to all PCI slots. VT7 BIOS Setup 3-9 NOTE: Set this option to [No] setting if there are adapters that cannot be automatically detected by the system and will cause malfunction. Intel OnScreen Branding: This item determines whether to display the "Intel Inside" logo or not at system boots up. User's Manual 3-10 Chapter 3 3-4. Advanced Chipset Features DRAM Clock/Drive Control: Click <Enter> key to enter its submenu: DRAM Timing: This item determines the timing method of the DRAM modules. [Manual]: This option allows you to select the best option in the following sub-items manually. [Auto By SPD]: This option allows the system to run the SPD (Serial Presence Detect) data structure stored in the DRAM module automatically. [Turbo]: This option allows the system to run at a speed faster than the one by [Auto By SPD] option. [. . . ] However, we will try to do our best to help every customer. Please also remember that for many of our technical support team English is a second language, you will have a better chance of getting a helpful answer if your question can be understood in the first place. Be sure to use very, simple, concise language that clearly states the problem, avoid rambling or flowery language and always list your system components. Here is the contact information for our branch offices: VT7 How to Get Technical Support I-3 North America and South America: ABIT Computer (U. S. A. ) Corporation 45531 Northport Loop West, Fremont, California 94538, U. S. A. [. . . ]