User manual ABLEREX MSII10000

[. . . ] If you smell combustion gases: B Turn off the heater. Assembly, modifications B The assembly and modifications during the installation of the heater can only be performed by an authorised installer. B Do not modify the pipes which conduct combustion gases. B Do not close or reduce air circulation vents. [. . . ] B Check if the flow and pressure through the installed reducer are appropriate for the consumption of the heater (see technical data in the table 4). 4 Minimum clearances Combustion gases · All gas heaters must be connected in a leak-roof manner to a gas evacuation pipe of adequate dimensions. · The flue must: ­ be vertical (reduced horizontal sections or no horizontal sections at all) ­ be thermally insulated ­ have an exit above the maximum roof level · A flexible or rigid pipe should be used, fit it inside the flue socket. The external diameter of the pipe should be slightly smaller than the dimension specified in the appliances dimensions table. · Must be mounted a protection wind/rain in the extremity of the evacuation pipe. Caution: Ensure that the extremity of the evacuation pipe is placed between the ledge and the ring of the flue. 3. 2 Selection of installation the place of Requirements regarding the place of installation · Do not install the heater in rooms with a volume of less than 8 m3 (not including the volume of the furniture providing this does not exceed 2 m3. · Comply with the specific instructions for each country. · Assemble the gas heater in a well-ventilated location where it will not be exposed to temperatures below zero and in a place where there is an evacuation pipe for combustion gases. · The gas heater must not be installed over a heat source. 6 720 607 WRDG 9 Installation If these conditions cannot be met, a different location must be selected for the gas intake and evacuation. Surface temperature The maximum surface temperature of the heater is less than 85 °C, with the exception of the combustion gases evacuation device. No special protection measures are required for flammable construction materials or built-in furniture items. 6 Burner pressure 5. 3 Conversion to a different type of gas Only use the original conversion kits. The conversion must only be performed by a qualified technician. The original conversion kits are supplied with assembly instructions. 14 6 720 607 WRDG Maintenance 6 Maintenance i Maintenance must only be performed by a qualified technician. After one or two years of use a general overhaul must be performed. Warning: Without a water filter installed, turning on the heater is prohibited. 6. 2 Warning: Before maintenance work: performing any B Close the water flow valve. B Order the spare parts according to the spare parts catalogue for the heater. B Replace the joints and removed O-rings with new ones. B Only the following lubricants must be used: ­ Hydraulic part: Unisilikon L 641 (8 709 918 413) ­ Coil unions: HFt 1 v 5 (8 709 918 010). Startup after maintenance work B Tighten all connections once more. B Read chapter 4 "Use" and chapter 5 "Adjustments". 6. 3 Purge the appliance IIf there is a risk of freezing, proceed as follows: B Remove the fixing lock from the filter screw cap (no. B Empty all the water contained in the heater. 6. 1 Periodic maintenance work Functional check B Check the operation of all safety, adjustment and monitoring elements. Heat exchanger B Check the heat exchanger is clean. B In case of dirt: ­ Remove the heat exchanger and take out the limiter. [. . . ] B Turn on the heater at nominal power and with the temperature selector adjusted to maximum temperature. In these conditions, the heater must turn off two minutes afterwards, at most. Remove the pipe and replace the evacuation pipe. * These procedures must be performed by a qualified installer. 16 6 720 607 WRDG Problems 7 7. 1 Problems Problem/cause/solution Assembly, maintenance and repairs must be performed by qualified technicians only. [. . . ]