User manual ACCESS VIRUS TI SNOW QUICKSTART MANUAL

[. . . ] Power On/Off Connect it to your other equipment Audio I/O This manual, as well as the software and hardware described in it, is furnished under license and may be used or copied only in accordance with the terms of such license. The content of this manual is furnished for informational use only, is subject to change without notice and should not construed as a commitment by Kemper Digital GmbH. Kemper Digital GmbH assumes no responsibility or liability for any errors or inaccuracies that may appear in this book. Except as permitted by such license, no part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, recording, by smoke signals or otherwise without the prior written permission of Kemper Digital GmbH. [. . . ] If you wish to save a patch you have created or edited, you first need to press the STORE button on the lower row. If you are not already in edit mode, you must press EDIT/SHIFT followed by STORE. There are several options to choose from: Store To RAM: This is the option to choose when saving a patch to the internal memory of the Virus. A back-up battery ensures that this memory is still retained when the power is off. Compare: Choose this option to compare your edited patch with the original. Sysex Dump: Choose this if you want to send the patch to another MIDI device, such as another Virus TI, or a MIDI sequencer for backup purposes. Store Single Menu/Multi Edit Buffer: When not in Single mode choose this option for patch-management functions - for details see the description below. The next step is to choose the specific RAM location in which to store your patch. Destination Select the specific Bank you wish to store you patch to. Patch Name As an alternative to selecting the patch to overwrite by number, you can locate it by name. Once you have selected the right location for your new patch, you may want to give it a new name. to access the naming page , press STORE again. Use the Value knobs or buttons to select the desired letter or symbol, and move through the characters with the PARAMETER buttons. Once you are satisfied with the name, press STORE again to complete the process. If you are in Single mode, press STORE to send the Single patch to your external device. If you are in Multi mode, press STORE to send the Arrangement (this contains all the patch information for each Part). If you only want to send the Single patch of the currently selected Part, select "Dump Single" instead of "Arrangement" and press STORE to send it. If you are in Multi Mode when you enter the Store menu, it will be assumed that you wish to store the current Multi setup. Select the Multi slot you wish to use and follow the same proceedure as when storing a Single patch. If you are in Multi mode and want to store the single patch of the current Part, select "Store Single Menu" from the list of options under "Function". If you are in Sequencer mode (or Virus Control mode) and wish to copy all of the single patches to the Multi mode edit buffer, select "Multi Edit Buffer" from the list of options under "Function". If you suddenly realise that you are about to overwrite your favourite patch and decide to bail out, press EXIT at any time to get straight back out of the Store menu. [. . . ] Compliance with these requirements provides a reasonable level of assurance that your use of this product in residental environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the user manual, may cause interference harmful to the operation of other electronic devices, Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determinated by turning the unit , , OFF" and , , ON", please try to eliminate the problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilise power outlets that are on branch (Circuitbreaker or fuse) circuits or install AC line filter/s. [. . . ]