User manual ACEC HCW65

[. . . ] If other types of flue or appliance are fitted, ensure that there is an adequate supply of air into the room. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. 3 - INSTALLATION 3. 1 - Fixing the front panel to the screen Extract the metal screen by turning it outwards unlocking, at the same time the stop on the left hand side of the hood (fig. 1), drill the panel, using the cardboard template provided and fix it to the screen using the 3. 9 x 13 screws provided. [. . . ] Adjust the slide of the screen by turning the two screws V. 3. 2 - Fixing to the wall Drill the wall using the cardboard template provided, fit plugs into the holes and fix the two metal brackets using the four screws provided with the accessories. The rear hooks on the hood can be adjusted both in height and depth, allowing the hood to be aligned 2 with the cupboards on either side (fig. In some models the rear hooks can only be adjusted horizontally (fig. 3), in any case, after hooking the hood to the wall it will always be necessary to adjust the depth of the metal spacer on the lower part of the hood (fig. 3. 3 - Fixing to cupboards on either side Drill the side cupboards using the cardboard template provided, remove the screen (see paragraph 3. 1). 5), fix the hood to the cupboards using the 3. 5 x 16 screws provided, screwing them from the inside (fig. 3. 4 - Ducting or recycling connection 1 - Ducting connection Kitchen fumes are ducted to the outside of the building through an outlet pipe (fig. The outlet from the hood must be connected to external ducting by means of rigid or flexible pipes Ø 100 or 120 mm, to be fixed using suitable pipe connectors (not provided). 3. 1 - Metal grease filters 1 - Cleaning The metal grease filters should be cleaned every two months with normal usage and can be cleaned in a dishwasher or by hand using a mild detergent or liquid soap. 2 - Removal a - Open the metal grille pushing the knobs towards the centre while pulling downwards (fig. b - Remove the wire clips and remove the filters (fig. 3. 2 - Synthetic fibre filter 1 - This type of filter is printed with red dots. When the filter becomes saturated the red colour of the dots will spread over the whole surface of the filter. At this point the filter has to be replaced. The saturated filter cannot be cleaned or regenerated. 2 - Replacement a - Open the metal grille pushing the knobs towards the centre while pulling downwards (fig. b - Remove the wire clips and replace the synthetic fibre filter (fig. [. . . ] b - Remove the wire clips and replace the synthetic fibre filter (fig. 3. 3 - Charcoal filters 1 - Functioning In the recycling mode the charcoal filters absorb smells and odours. The charcoal filter cannot be washed or regenerated and should be replaced every 2 months or more frequently if the hood is used consistently. [. . . ]