User manual ACER AAG5450

[. . . ] Acer Altos G5450 Series User's Guide Copyright © 2007 Acer Incorporated All Rights Reserved. Acer Altos G5450 Series User's Guide Changes may be made periodically to the information in this publication without obligation to notify any person of such revision or changes. Such changes will be incorporated in new editions of this manual or supplementary documents and publications. This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims the implied warranties of merchantability or fitness for a particular purpose. [. . . ] (1) Press the release latch of the slot cover opposite the selected expansion slot. (2) Pull out the slot cover and store it for reassembly later. 59 Caution: Do not discard the slot cover. If the expansion card is removed in the future, the slot cover must be reinstalled to maintain proper system cooling. Remove the expansion card from its protective packaging, handling it by the edges. (3) Insert the card into the selected slot. Make sure that the card is properly seated. (4) Press the release latch to secure the card in place. (5) Connect the necessary cables to the expansion card as required. 5 Observe the post-installation instructions described on page 36. When you turn on the system, the BIOS setup automatically detects and assigns resources to the new device (applicable only to Plug-and-Play expansion card). 60 3 System upgrade Installing the BMC module The optional BMC module allows system administrators to manage the Altos G5450 system remotely over a network. To install the BMC module: 1 2 3 4 5 Perform the pre-installation instructions described on page 35. If necessary, remove any boards or cables that prevent access to it. If necessary, open the holding clips of the IPMI1 slot. Remove the BMC module from its protective packaging, handling it by the edges. (1) Align the module so that the notch on the IPMI1 slot fits the keyed edge of the module, then press the module at both ends to seat it fully into the slot. When the module is properly installed, the holding clips will automatically lock in place. (2) Secure the module with the one screw. 6 Observe the post-installation instructions described on page 36. 61 Installing the ARMC/3 module Remote system management just got easier with the new ARMC/3 module. The module provides high performance KVM (keyboardvideo-mouse) redirection and features a dedicated NIC port for faster network access. To install the ARMC/3 module on system board: 1 2 3 4 5 Perform the pre-installation instructions described on page 35. If necessary, remove any boards or cables that prevent access to it. If necessary, open the holding clips of the IPMI1 slot. Remove the ARMC/3 module from its protective packaging, handling it by the edges. (1) Align the module so that the notch on the IPMI1 slot fits the keyed edge of the module, then press the module at both ends to seat it fully into the slot. When the module is properly installed, the holding clips will automatically lock in place. To install the ARMC/3 module on the BMC module: 1 Perform the pre-installation instructions described on page 35. 62 2 3 4 5 3 System upgrade Locate the SODIMM1 slot on the BMC module board. If necessary, remove any boards or cables that prevent access to it. If necessary, open the holding clips of the SODIMM1 slot. [. . . ] Otherwise, the screw holes on the component may not match those on the rack. 121 Rack installation procedures Preparing the server for rack installation 1 Remove the foot stands from the server. (1) Lay the server on its side on a flat, stable surface. (2) Use a flat-blade screwdriver to remove the stoppers securing the foot stands to the chassis. (3) Detach the foot stands from the server. [. . . ]