User manual ACER AM501

[. . . ] 10 TROUBLESHOOTING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 1 IMPORTANT SAFETY INSTRUCTIONS 1. Please read these instructions thoroughly. [. . . ] Please contact your service center for any questions regarding service and repairs to guarantee the device`s performance and reliability. 18. The power socket must be installed near the equipment to be easily accessible. The application of this monitor is restricted to special controlled luminous environments. The screen surface trend to reflect annoying light of lamps and sunlight. To avoid these reflections the monitor should not be positioned in front of a window or directed to luminaries. The monitor is in compliance with Reflection Class III according to ISO 9241-7. 2 FEDERAL COMMUNICATIONS COMMISSION ( FCC Statement ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: which the receiver is connected; · Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the manufacturers may void the user`s authority to operate this equipment. · Reorientate or relocate the receiving antenna; · Increase the separation between the equipment and receiver; · Connect the equipment with a power socket on a circuit different from that to A shielded-type video signal cable is required in order to meet the FCC emission limits and also to prevent interference to nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment. CANADIAN DOC NOTICE For Class B Computing Devices This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le mat ériel brouilleur du Canada. 3 CONNECTING THE MONITOR AND SWIVEL BASE 1. Place the monitor with its tube down on a stable surface. Align the four tabs of the swivel base with the slots in the bottom of the monitor. Insert the tabs into the slots of the monitor 4. Now slowly slide the swivel base toward the front of the monitor till you hear the spring lock click into place. REMOVING THE MONITOR AND SWIVEL BASE If you need to remove the swivel base, push the spring lock and then pull the swivel base away from the monitor. NOTE: Special attention should be paid to the control knobs and LED indicators on the front panel when you place the monitor with its tube down. [. . . ] Make sure that the computer switch is in the "On" position. Make sure that the video cable`s D-shaped connector is properly connected to the video adapter port on the back of the PC. Check to make sure that the brightness and contrast controls are not turned to their dimmest position. [. . . ]