User manual ACER ASPIRE 7739ZG

[. . . ] Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. CAUTION for plug as disconnecting device Observe the following guidelines when connecting and disconnecting power to the power supply unit: Install the power supply unit before connecting the power cord to the AC power outlet. Unplug the power cord before removing the power supply unit from the computer. If the system has multiple sources of power, disconnect power from the system by unplugging all power cords from the power supplies. CAUTION for accessibility Be sure that the power outlet you plug the power cord into is easily accessible and located as close to the equipment operator as possible. [. . . ] The operating system files may be damaged or missing. Insert the startup disk you created during Windows setup into the floppy drive and press Ctrl + Alt + Del to restart your computer. This will automatically diagnose your system and make necessary fixes. However, if the diagnostic utility still reports a problem, then you may have to perform the recovery process to restore your system to its original default factory settings. Note: For more information about recovering your system, refers to the RCD instruction sheet. English If the LED is lit, check the following: · · Q: Nothing appears on the screen. A: Your computer's power management function automatically blanks the screen to save power. Just press any key to turn the display back on. If pressing a key does not work, you can restart your computer. If restarting your computer does not work, contact your dealer or the technical support center for assistance. Q: The printer does not work. 6 A: Do the following: · · · Make sure that the printer is connected to a power outlet and that it is turned on. Make sure that the printer cable is connected securely to the system's parallel port and the corresponding port on the printer. Do not step on the power cord or place heavy objects on top of it. Carefully route the power cord and any cables away from personal traffic. When unplugging the power cord, do not pull on the cord itself but pull on the plug. The total ampere rating of the equipment plugged in should not exceed the ampere rating of the cord if you are using an extension cord. Also, the total current rating of all equipment plugged into a single wall outlet should not exceed the fuse rating. · · Cleaning and servicing To clean your computer and keyboard 1 2 Turn off the computer and unplug the power cord. Use a soft cloth moistened with water and gently wipe the exterior of the computer and the keyboard. Do not use liquid or aerosol cleaners. To clean your pointing device To clean a regular mouse (with rubber ball) 1 Open the circular cover at the base of the mouse. 2 Take out the rubber ball and wipe it with a soft, damp cloth. 8 3 Put the ball back and replace the cover. English English English To clean an optical mouse For users of an optical mouse, refer to the documentation that came with your mouse for maintenance instructions. To clean your monitor Make sure that you keep your screen clean. For cleaning instructions, refer to the documentation that came with your monitor. When to contact a service technician · · · · If you dropped and damaged the computer If liquid has been spilled into the computer If the computer is not operating normally If a computer problem persists even after you have checked and applied the troubleshooting tips discussed in the "Frequently asked questions" section on page 5 If your problem is not listed in the "Frequently asked questions" section on page 5 If you want to replace or upgrade any of your computer's internal components · · Asking for technical assistance For technical assistance, contact your local dealer or distributor. You may also access the Web site (http://global. acer. com/support/index. htm) for information on how and where to contact the service centers available in your area. 9 FCC notice This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Depending on configurations, this product may or may not contain wireless radio devices (such as wireless LAN and/or Bluetooth modules). Below information is for products with such devices. European Union (EU) R&TTE Directive 1999/5/EC as attested by conformity with the following harmonized standard: · Article 3. 1(a) Health and Safety · · · · · · · · · · · · · EN60950-1:2001 EN50371:2002 EN301 489-1 V1. 4. 1:2002 EN301 489-17 V1. 2. 1:2002 EN301 489-3 V1. 4. 1:2002 (Applied to models with 27MHz wireless mouse/keyboard) EN301 489-7 V1. 2. 1:2002 (Applied to models with 3G function) EN301 489-24 V1. 2. 1:2002 (Applied to models with 3G function) EN300 328 V1. 5. 1:2004 EN301 893 V1. 2. 3:2003 EN300 220-1 V1. 3. 1:2000 (Applied to models with 27MHz wireless mouse/keyboard) EN300 220-3 V1. 1. 1:2000 (Applied to models with 27MHz wireless mouse/keyboard) Article 3. 1(b) EMC Article 3. 2 Spectrum Usages 15 List of applicable countries EU member states as of May 2004 are: Belgium, Denmark, Germany, Greece, Spain, France, Ireland, Italy, Luxembourg, the Netherlands, Austria, Portugal, Finland, Sweden, United Kingdom, Estonia, Latvia, Lithuania, Poland, Hungary, Czech Republic, Slovak Republic, Slovenia, Cyprus and Malta. Usage allowed in the countries of the European Union, as well as Norway, Switzerland, Iceland and Liechtenstein. This device must be used in strict accordance with the regulations and constraints of the country of use. [. . . ]