User manual ACER ASPIRE G1210

[. . . ] This plug will only fit into a groundingtype power outlet. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding-type plug. Do not allow anything to rest on the power cord. [. . . ] It should be a detachable type: UL listed/CSA certified, type SVT/SJT, rated 6A 125V minimum, VDE approved or its equivalent. Maximum length is 15 feet (4. 6 meters). v &'5206DIHW\:DUQLQJ DANGER INVISIBLE RADIATION WHEN OPEN. VORSICHT UNSICHTBARE LASERSTRAHLUNG WENN GEÖFFNET. ATTENTION RADIATION DU FAISCEAU LASER INVISIBLE. VARO AVATTAESSA OLET ALTTIINA NÄKYMÄTTÖMÄLLE LASERSÄTEILYLLE ÄLÄ KATSO SÄTEESEEN. OSYNLING LASERSTRÄLNING NÄR DENNA DEL ÄR ÖPPNAD. VARNING OSYNLING LASERSTRÄLNING NÄR DENNA DEL ÄR ÖPPNAD. ADVARSEL LASERSTRÄLING VED ÄBNING. SE IKKE IND I STRÄLEN. CLASS 1 LASER PRODUCT APPAREIL A LASER DE CLASSE 1 LASER KLASSE 1 LOUKAN 1 LASERLAITE PRODUIT LASER CATEGORIE 1 vi )&&&ODVV%5DGLR)UHTXHQF\ , QWHUIHUHQFH6WDWHPHQW Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. 12 2. 3. 3 Installing Drives into the 3. 5-inch Drive Bay . . . . . . . . . . . . . 14 2. 4 2. 5 Installing Expansion Boards. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Reinstalling the Cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 ix 1 1. 1 Features Front Panel 1 2 3 4 5 6 1. Hard disk drive LED ASPIRE G1210 (Aspire) Housing 1 1. 2 Rear Panel 1 2 3 4 5 6 1. Expansion card brackets 2 Installation Guide 1. 3 Inside Components 1 4 5 2 3 1. 3. 5-inch diskette drive/HDD drive bay ASPIRE G1210 (Aspire) Housing 3 2 Component Installation Turn off the system power before opening the system or connecting or removing any peripheral device. 2. 1 Opening the Housing 1. 2. Place the system unit on a flat, steady surface. Remove the four screws from the rear panel. You will need them when replacing the housing cover. 4 Installation Guide 3. 4. Push the housing cover slightly backward. [. . . ] Pull the metal bay cover to the side until the other end is released, then pull it to remove it from the housing. 5. Insert the 5. 25-inch disk drive into the drive bay and secure it with four screws on the side. ASPIRE G1210 (Aspire) Housing 13 6. Connect the power cable and the diskette drive cable. Make sure that the other end of the diskette drive cable is connected to its corresponding connector on the system board. 14 Installation Guide 2. 3. 3 Installing Drives into the 3. 5-inch Drive Bay Follow these steps to install a 3. 5-inch diskette drive or a hard disk drive: 1. Remove the 3. 5-inch drive frame from the housing by pressing the tab on top and pivoting the frame outward. 2. Pull out the metal drive cover. ASPIRE G1210 (Aspire) Housing 15 3. Install a 3. 5-inch disk drive and secure it with the necessary screws. Follow the same procedure to install the hard disk drive. When installing drives in the 3. 5-inch drive bay, the hard disk is placed always below of the 3. 5-inch diskette drive. 16 Installation Guide 4. Reinstall the frame into the housing as in the following figure: a. [. . . ]