User manual ACER ASPIRE V5-552P

[. . . ] einbau Chassis des Fahrzeugs geerdet wird. If the fuse blows frequently, consult your ACER • Sicherstellen, dass sich kein Kabel am Chassis oder unter den Sitzen des Fahrzeugs verfangen hat. € It is recommended to connect speakers with Hinweise zu elektrischen Anschlüssen: maximum power of more than 50 W (both at the • Die Sicherung mit einer der entsprechenden rear and at the front, with an impedance of 4 Ω to Nennleistung ersetzen. Häufig durch, wenden Sie sich an ihren ACER • To prevent short circuits, cover the terminals of Autoradiohändler. [. . . ] However, you should make adjustments corresponding to your specific car. If you have any questions or require information regarding installation kits, consult your ACER IN-CAR ENTERTAINMENT dealer or a company supplying kits. € If you are not sure how to install this unit correctly, have it installed by a qualified technician. Vor dem Einbau des Geräts Before installing the unit • Bauen Sie die ursprünglich im Fahrzeug vorhandene Audioanlage zusammen mit ihren • Remove the audio system originally installed in Befestigungsteilen aus. Alle aus dem Fahrzeug the car, together with its mounting brackets. Be ausgebauten Schrauben und anderen Teile müssen sure to keep all the screws and parts removed zur Wiederverwendung aufbewahrt werden. € Bei der Montage dieses Gerätssollen immer • When mounting the unit, be sure to use the die mitgelieferten Schrauben wie beschrieben screws provided, as instructed. Wenn andere Schrauben used, parts could become loose or damaged. € Make sure not to block the fan on the rear to • Beim Festziehen von Schrauben oder Steckschrauben maintain proper ventilation when installing the immer darauf achten, keine Kabel einzuklemmen. € Sicherstellen, dass nicht das Gebläse an der Rückseite verdeckt wird, um richtige Ventilation When installing the unit without using the beim Einbau zu gewährleisten. Mounting sleeve • Use flat head screws or round head screws, depending on installation location. The leads of the wiring harness and those of the connector from the car body may be different in color. 2 Connect the colored leads of the wiring harness in the order specified in the illustration below. 4 Finally connect the wiring harness to the unit. € The terminals and cables of all models are shown in the illustration for the purpose of explanation. ) To the OE remote adapter *4 Zum OE-Remote-Adapter *4 Au adaptateur pour télécommande au volant *4 Naar de OE-afstandsbedieningsadapter *4 Fuse block Sicherungsblock Porte-fusible Zekeringblok See each diagram on pages 5 and 6. *3 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on. Do not connect the lead directly to the battery. *4 Do not connect the lead to any device other than the OE remote adapter. You can connect an amplifier to upgrade your car stereo system. € Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit. € Disconnect the speakers from this unit, and connect them to the amplifier. [. . . ] *7 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit. *8 Video cord (not supplied for this unit). *9 When using the cable, you need to change the setting on the unit (see page 27 of the INSTRUCTION MANUAL). [. . . ]