User manual ACER ASPIRE Z1801

[. . . ] Record the model number, serial number, purchase date, and place of purchase information in the space provided below. The serial number and model number are recorded on the label affixed to your computer. All correspondence concerning your unit should include the serial number, model number, and purchase information. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopy, recording, or otherwise, without the prior written permission of Acer Incorporated. Model Number : _________________________________ Serial Number: ___________________________________ Purchase Date: ___________________________________ Place of Purchase: ________________________________ Acer and the Acer Logo are registered trademarks of Acer Inc. [. . . ] Avoid dusty areas and extremes of temperature and humidity. You may place your computer beside your desk or under your table, as long as it does not block the space that you need for working and moving. · · 28 3 Setting up your computer Positioning your monitor Place your monitor at a comfortable viewing distance, usually 50 to 60 centimeters away. Adjust the display in such a way that the top of the screen is at or slightly below eye level. Positioning your keyboard The location of the keyboard is a very important factor to your posture. Placing it too far away will make your body lean forward forcing you to sit in an unnatural position. Placing it too high will add tension to your shoulder muscles. · The keyboard should be placed just above your lap. Adjust the keyboard height by flipping the folding stands located under the keyboard. Keep your lower arms parallel to the floor as you type. Your upper arms and shoulders should be relaxed. If you feel any shoulder or neck strain, stop for a while and check your posture. Position your keyboard in front of your monitor. In the same manner, connect a USB printer by plugging the printer cable into any of the USB ports located on the front and rear panel. 39 Connecting the modem (optional) Set up your modem connection by plugging the telephone line and modem line of your computer. into their corresponding ports on the rear panel 40 3 Setting up your computer Connecting to the network You can connect your computer to a Local Area Network (LAN) using a network cable. To do so, simply plug the network cable into the network port computer. (white port) located on the rear panel of your Note: Consult your operating system manual for information on how to configure your network setup. 41 Connecting multimedia devices You can connect multimedia devices such as microphone, earphone or headphone, external speakers, and audio line-in device. These devices will allow you to take advantage of your computer's multimedia features. Note: The multimedia devices shown below are for your reference only. Actual device model may vary in selecrt countries. Plug the devices in as follows: Note: For information on how to configure multimedia devices, consult the documentation that came with each device. · microphone: connects to the Microphone-in port (pink port) located on the front and rear panel of your computer Note: The system has two microphone-in jacks (front and rear). However, you can not use both of them at the same time. By default, your system enables the microphone-in jack in front and disables the one at the back. 42 3 Setting up your computer · earphones, headphones: connect to the Headphone-out port (lime port) located on the front panel of your computer Note: To adjust the volume of the headphones, click the Volume icon located on the taskbar at the bottom of your screen. When the volume control pops up, drag the Volume control lever to the desired level. You can also use the Volume control/mute knob on the keyboard. 43 · external speakers: connect to the Audio-out/Line-out jack (lime jack) and Speaker power jack panel of your computer located on the rear · audio line-in device: connects to the Audio-in/Line-in jack (light blue jack) located on the rear panel of your computer 44 3 Setting up your computer Connecting USB devices Universal Serial Bus (USB) is a serial bus design that is capable of cascading peripherals such as a digital camera, keyboard, mouse, joystick, scanner, printer and modem. With USB, complex cable connections can be eliminated. [. . . ] The operating system files may be damaged or missing. Insert the startup disk you created during Windows setup into the floppy drive and press Ctrl + Alt + Del to restart your computer. This will automatically diagnose your system and make necessary fixes. However, if the diagnostic utility still reports a problem, then you may have to perform the recovery process to restore your system to its original default factory settings. · Note: For more information about recovering your system, refer to page 78. 82 Q: Nothing appears on the screen. 6 Frequently asked questions A: Your computer's power management function automatically blanks the screen to save power. [. . . ]