User manual ACER ASPIRE ZC-102

[. . . ] Easy programming for the control of your TUNER (RADIO) To programme the remote control to operate your TUNER, proceed as described for the CD PLAYER but using the TUNER key instead of the CD key. Please ensure that you refer to the codes listed under the TUNER section and not the CD PLAYER section. Easy programming for the control of your TAPE RECORDER (TAPE DECK) To programme the remote control to operate your TAPE RECORDER, proceed as described for the CD PLAYER but using the TAPE key instead of the CD key. Please ensure that you refer to the codes listed under the TAPE section and not the CD PLAYER section. [. . . ] Enter code 0 0 2 , using the numerical keys. Press key 1 and count the number of LED flashes. This number corresponds to the first digit of the code. Press key 2 and count the number of LED flashes. This number corresponds to the second digit of the code (if the digit is 0, the LED does not flash). Press key 3 and count the number of LED flashes. This number corresponds to the third digit of the code (if the digit is 0, the LED does not flash). Steps C, D and E can be repeated as often as necessary. To read the currently used code for the control of a VCR, SAT, DVD/AUX, CD, TAPE, TUNER or AMP device, proceed as described above for your TV SET. Complete steps A to F, pressing the VCR , SAT , DVD , CD , TAPE , TUNER or AMP key respectively. Write down the code number as indicated by the LED. After entering the code the LED will flash twice indicating that the code has been accepted. Point the remote control towards your TV and press the key. If your TV does not respond by going into Stand-By mode then repeat steps 3 to 8 and enter the next code in the list. If your TV goes into Stand-By mode when the key pressed then your remote control has found a compatible code. Next test all of the other function buttons. If certain functions are not working correctly then restart the process moving onto the next code number as this may well improve the situation. If the codes in the list fail to operate your TV then next move onto the automatic code scan function (see below). Easy programming for the control of your AMPLIFIER To programme the remote control to operate your AMPLIFIER, proceed as described for the CD PLAYER. Complete steps 1 to 10, using the AMP key on your remote control. Please ensure that you refer to the codes listed under the AMPLIFIER section and not CD PLAYER section. Code scan If programming using the codes in the enclosed list failed to work then you must next try the automatic code scan. [. . . ] Within 5 seconds, press 1 for brightness, 2 for colour, 3 for contrast, 4 for tremble, 5 for bass, 6 for balance. To adjust the settings use the VOL+ and VOL- keys. After 5 seconds, your remote control returns to standard mode for the selection of channels. Finding out what code number you are using If you have programmed your remote control by means of the automatic code scan, or if you have forgoten the code you have stored then the following procedure will replay the codes being used. [. . . ]