User manual ACER B6

[. . . ] You can also put the computer in suspend mode by selecting the Suspend command from the Start menu. 1-2 User's Guide 1. 1. 2 Rear Panel Features Figure 1-2 Table 1-2 # 1 2 3 4 5 6 7 8 9 10 11 Item Rear Panel Features Rear Panel Features Description Turns power on and off Connects a power cord Connects an external monitor Connects a printer or other parallel device Connect a serial mouse or other serial device Connects a PS/2 keyboard Connects a PS/2 mouse Connects to speakers Connects a microphone Connects a USB device Connects a USB device On/off switch Power cord socket External CRT port Parallel port Serial port PS/2 keyboard port PS/2 mouse port Speaker port Microphone port USB port 2 USB port 1 System Housing 1-3 1. 2 Finding a Suitable Area to Install the System This system has the following dimensions. Figure 1-3 System Dimensions Locate a suitable area to place the system. Allow ample space on all sides of the unit for cords and cable connections. [. . . ] The screw is located on the lower-left side of the frame. Then gently detach the disk frame from the housing. System Housing 1-15 Figure 1-15 Removing the Disk Frame 3. Unscrew the hard disk drive frame to detach as shown below. Figure 1-16 Removing the Hard Disk Drive Frame 1-16 User's Guide Installing a Hard Disk Drive 1. Attach the hard disk drive to the hard disk drive frame with the necessary screws as shown below. Figure 1-17 Installing the Hard Disk into the Hard Disk Drive Frame 2. Reattached the hard disk drive frame to the disk frame. Figure 1-18 Reattaching the Hard Disk Drive Frame to the Disk Frame System Housing 1-17 Installing a 3. 5-inch Diskette Drive 1. Attach the 3. 5-inch diskette drive to the 3. 5-inch diskette drive with the necessary screws as shown below. Figure 1-19 Installing a 3. 5-inch Disk Drive into 3. 5-inch Drive Frame 1-18 User's Guide Installing a CD-ROM Drive 1. Attach the CD-ROM drive to the CD-ROM drive with the necessary screws as shown below. Figure 1-20 Installing a CD-ROM Drive System Housing 1-19 1. 5. 4 Installing a System Board Installation Procedures 1. Align the board with the pegs on the housing frame. Figure 1-21 Installing the System Board 2. Gently press the board until it is properly seated. Secure the board with the required screws. 1-20 User's Guide 4. Attached the USB connector cable to the system board. Using a screw driver, secure the connector to the housing's opening at the back. The USB connector opening is located on the lower-left side of the housing (at the back). Figure 1-22 Attaching the USB Connector Cable to the System Board For more information about the system board's connectors, please refer to the system board's manual. 5. Secure the Front I/O Board (located in front of the housing) with the appropriate screw as shown below. System Housing 1-21 Figure 1-23 Installing the Front I/O Board 6. [. . . ] Secure the board with the screw. Do not neglect this step. The board uses the 1-26 User's Guide screw for grounding. 1. 8 Replacing the Cover After you install the necessary system components into the housing, you must reinstall the cover. [. . . ]