User manual ACER G196WL

[. . . ] It can be displayed up to three (3) times. Make sure to adjust the resolution of your PC before reaching the maximum count. Note The resolution displayed on the screen is the optimal resolution for this product. Adjust your PC resolution so that it is the same as the optimal resolution for this product. Introduction Front MENU button [MENU/ ] Opens the on-screen menu and exits from the menu. [. . . ] If the display exceeds 85 Hz, the display will work properly but the "Not Optimum Mode", "Recommended Mode 1440 x 900 60 Hz" message appears for one minute and then disappears. Please change to the recommended mode during this one-minute period. (The message is displayed again if the system is rebooted. ) Q: A: A: A: Q: A: There is no image on the screen. Is the power indicator on the monitor blinking at 1 second intervals?Press a key on the keyboard to activate the monitor and restore the image on the screen. If there is still no image, press the 'SOURCE/ ' button. Then press any key on the keyboard again to activate the monitor and restore the image on the screen. You may get a blank screen if you boot the system before you connect the DVI cable, or disconnect and then reconnect the DVI cable while the system is running as certain types of graphic cards do not send out video signals. Connect the DVI cable and then reboot the system. I cannot see the On Screen Display. Q: A: Have you locked the On Screen Display (OSD) Menu to prevent changes?Unlock the OSD by pressing the [MENU/ ] button for at least 5 seconds. The screen shows strange colors or just black and white. Q: A: A: Q: A: Q: A: Is the screen displaying only one color as if looking at the screen through a cellophane paper?Make sure the video card is fully inserted in its slot. http://www. samsung. com/monitor/magictune MagicTuneTM doesn't work properly. Q: A: Q: A: Have you changed your PC or video graphic card?The program can be downloaded http://www. samsung. com/monitor/magictune Did you install the program?Reboot the computer after installing the program for the first time. If a copy of the program is already installed, remove it, reboot the computer, and then install the program again. You need to reboot the computer for it to operate normally after installing or removing the program. Note Visit the MagicTuneTM website and download the installation software for MagicTuneTM MAC. Check the following items if there is trouble with the monitor. Check if the power cord and the video cables are properly connected to the computer. Check if the computer beeps more than 3 times when booting. (If it does, request an a service for the main board of the computer. ) If you installed a new video card or if you assembled the PC, check if the installed the adapter(video) driver and the monitor driver. Check if the scanning ratio of the video screen is set to between 56 Hz ~ 75 Hz. (Do not exceed 75 Hz when using the maximum resolution. ) If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove the Display Adapter in the "Control Panel System Device Administrator" and then reboot the computer to reinstall the adapter (video) driver. Note If problems repeatedly occur, contact an authorized service center. {963UW} Q&A Q: A: A: How can I change the frequency? [. . . ] http://www. samsung. com/monitor/magictune MagicTuneTM doesn't work properly. Q: A: Have you changed your PC or video graphic card?The program can be downloaded http://www. samsung. com/monitor/magictune Troubleshooting Q: A: Did you install the program?Reboot the computer after installing the program for the first time. If a copy of the program is already installed, remove it, reboot the computer, and then install the program again. [. . . ]