User manual ACER H276HL

[. . . ] Getting Started: A startup guide for basic switch installation and settings. Terms/Usage In this guide, the term “Switch” (first letter capitalized) refers to the SmartPro Switch, and “switch” (first letter lower case) refers to other Ethernet switches. Some technologies refer to terms “switch”, “bridge” and “switching hubs” interchangeably, and both are commonly accepted for Ethernet switches. A NOTE indicates important information that helps a better use of the device. [. . . ] Daylight Saving Time Offset: Use this drop-down menu to specify the amount of time that will constitute your local DST offset - 30, 60, 90, or 120 minutes. Time Zone Offset GMT +/- HH:MM: Use these drop-down menus to specify your local time zone's offset from Greenwich Mean Time (GMT. ) Daylight Saving Time Settings: From: Month / Day: Enter the month DST and date DST will start on, each year. From: HH:MM: Enter the time of day that DST will start on, each year. To: Month / Day: Enter the month DST and date DST will end on, each year. To: HH:MM: Enter the time of day that DST will end on, each year. 1AB standards-based method for switches to advertise themselves to neighbor devices, as well as to learn about neighbor LLDP devices. SNMP utilities can learn the network topology by obtaining the MIB information in each LLDP device. 56 –L2 Functions> LLDP > LLDP Global Settings LLDP: When this function is Enabled, the switch can start to transmit, receive and process the LLDP packets. For the advertisement of LLDP packets, the switch announces the information to its neighbor through ports. For the receiving of LLDP packets, the switch will learn the information from the LLDP packets advertised from the neighbor in the neighbor table. System Capabilities: Specifies whether the System Capabilities TLV is enabled on the port. The possible field values are: Enabled – Enables the System Capabilities TLV on the port. Disabled – Disables the System Capabilities TLV on the port. Click Apply to implement changes made and click Refresh to refresh the table information. 1 Extension TLV page is used to configure the LLDP Port settings. 1 Extension TLV From Port / To Port : A consecutive group of ports may be configured starting with the selected port. port VLAN ID : Specifies the Port VLAN ID to be enabled or disabled. VLAN Name : Specifies the VLAN name to be enabled or disabled in the LLDP port. If select Enabled, users can specifies the content of VLAN ID or VLAN Name or all. Protocol Identity : Specifies the Protocol Identity to be enabled or disabled in the LLDP port. If select Enabled, users can specifies the EAPOL, LACP, GVRP, STP or ALL. [. . . ] 0 To display the configuration of an IP interface on the Switch. Show ipif [<ipif_name>] The s how ipif command displays the current IP address of the switch. 101 6 Command Line Interface D-Link Web Smart Switch User Manual show switch Purpose Syntax Description Parameters Restrictions Example usage: To display the switch information: DGS-1500-28> show switch System Name System Contact System Location System up time System Time System hardware version System firmware version System boot version System Protocol version System serial number MAC Address DGS-1500-28> : : : : 0 days, 6 hrs, 32 min, 17 secs : 01/01/2009 06:32:19 : A1 : 1. Show switch The s how s witc h command displays the status of the switch. [. . . ]