User manual ACER H61 Install Guide

[. . . ] This product should never be placed near or over a radiator or heat register, or in a built-in installation unless proper ventilation is provided. This product should be operated from the type of power indicated on the marking label. If you are not sure of the type of power available, consult your dealer or local power company. This product is equipped with a 3-wire grounding-type plug, a plug having a third (grounding) pin. [. . . ] ADVARSEL LASERSTRÄLING VED ÄBNING. SE IKKE IND I STRÄLEN. CLASS 1 LASER PRODUCT APPAREIL A LASER DE CLASSE 1 LASER KLASSE 1 LOUKAN 1 LASERLAITE PRODUIT LASER CATEGORIE 1 vi )&&&ODVV%5DGLR)UHTXHQF\ , QWHUIHUHQFH6WDWHPHQW Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/television technician for help. Notice 1: The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2: Shielded interface cables, if any, must be used in order to comply with the emission limits. vii $ERXWWKLV0DQXDO Purpose This manual aims to give you all the information you need to install the system housing. Conventions The following conventions are used in this manual: NOTE Gives bits and pieces of additional information related to the current topic. WARNING Alerts you to any damage that might result from not following directions. CAUTION Suggests precautionary measures to avoid potential hardware or software problems. IMPORTANT Reminds you to take specific action relevant to the accomplishment of the procedure at hand. TIP Tells how to accomplish a procedure with fewer steps through little shortcuts. viii 7DEOHRI&RQWHQWV 1 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1. 1 1. 2 1. 3 Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Inside Components. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2 Component Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2. 1 2. 2 Opening the Housing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installing a System Board. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 2. 2. 1 2. 2. 2 2. 3 ESD Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For instructions on how to remove the tray cover, refer to your CD-ROM manual. H61 (Aspire) Housing 9 7. Replace the front panel by: a. b. Align the front panel tabs into their corresponding slots on the housing frame. Insert the front panel until the tabs click into place. 10 Installation Guide 8. Connect the power cable and the CD-ROM drive cable. H61 (Aspire) Housing 11 2. 3. 2 1. Installing a Drive into the 5. 25-inch Drive Bay Open the disk drive door. 2. Using a flat-head tool, open remove the bay panel. 12 Installation Guide A B 3. 4. Insert your thumb and forefinger into the holes on the metal bay cover. [. . . ]