User manual ACER H6520BD QUICK START GUIDE

[. . . ] After descaling is done, the steam function will be restored. This takes place regardless of the type of water used. Sound and light Calc-Clean reminder -- After 1 to 3 months of use, the Calc-Clean light starts flashing and the appliance starts beeping to indicate that you have to perform the Calc-Clean process (Fig. -- You can continue steam ironing for 1 hour while the Calc-Clean light flashes and the appliance beeps. [. . . ] Performing the Calc-Clean process with the Smart Calc-Clean container Do not leave the appliance unattended during the Calc-Clean process. Caution: Do not interrupt the process by lifting the iron up from the Calc-Clean container, as hot water and steam will come out of the soleplate. 2 Make sure that the appliance is plugged in and switched ON during the Calc-Clean process (Fig. 4 Place the Smart Calc-Clean container on the ironing board or any other even, stable surface (Fig. 5 Place the iron stably on the Smart Calc-Clean container. note:The Smart Calc-Clean container has been designed to collect scale particles and hot water during the Calc-Clean process. It is perfectly safe to rest the iron on this container during the entire process. 6 Press and hold the Calc-Clean button for 2 seconds until you hear short beeps (Fig. 7 During the Calc-Clean process, you hear short beeps and a pumping sound. Wait approximately 2 minutes for the appliance to complete the process (Fig. 8 When the Calc-Clean process is completed, the iron stops beeping (Fig. You have not done or have not The Calc-Clean light flashes and/or completed the Calc-Clean process. The Calc-Clean light flashes and the appliance beeps every time I press the steam trigger. You have not done or have not Perform the Calc-Clean process to enable completed the Calc-Clean the steam function again (see chapter process. This happens automatically when the steam generator has not been used or the steam trigger has not been pressed for more than 15 minutes. Set the on/off switch to ‘off ’ position and then to ‘on’ position. The appliance produces a loud pumping sound. Fill the water tank with water and press the steam trigger until the pumping sound becomes softer and steam comes out of the soleplate. ENGLISH Problem Water droplets come out of the soleplate. Possible cause After the Calc-Clean process, remaining water may drip out of the soleplate. Solution Wipe the soleplate dry with a piece of cloth. If the Calc-Clean light still flashes and the appliance still beeps, perform the Calc-Clean process (see chapter ‘IMPORTANT - Cleaning and maintenance’). [. . . ] 9 The Calc-Clean process has not been completed. Dirty water and impurities come out of the soleplate. Impurities or chemicals present Perform the Calc-Clean process regularly in the water have deposited in (see chapter ‘IMPORTANT - Cleaning and maintenance’). You have accidentally started the Calc-Clean process (see chapter ‘IMPORTANT Cleaning and maintenance’). [. . . ]