User manual ACER ICONIA W511

[. . . ] Further, this company reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or changes. All brand and product names mentioned in this manual are trademarks and/or registered trademarks of their respective companies. ii , 03257$17 6$)(7< , 16758&7, 216 1. Save these instructions for Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] Close the left panel. System Housing 2-31 2. 7 Installing an Expansion Board Follow these steps to install a PCI expansion board: 1. See section 2. 2 for more information on opening the housing panels. Remove the bracket cover opposite an empty PCI slot. Insert the board into the slot until it completely fits in. Secure the board with a screw. 2-32 AcerAltos 21000 System Guide 5. Follow the same steps when installing an ISA board. Just make sure that you remove the bracket cover opposite an ISA slot. System Housing 2-33 2. 8 Removing and Installing the Thermal Air Guide On the left side of the housing, a metal thermal air guide directs the hot air from the inside to the fan exhausts on the rear of the housing. The air guide helps in maintaining good air circulation within the housing. To avoid electric shock and damage to the system, DO NOT perform the following procedure while the system is ON. 2. 8. 1 Removing the Thermal Air Guide Follow these steps to remove the thermal air guide: 1. Unplug all power cables from the wall socket. Refer to section 2. 2 for instructions on opening the door. Remove the two screws that secure the air guide to the housing. Save the screws. 4. Carefully remove the air guide from the housing and set it aside. 2-34 AcerAltos 21000 System Guide 2. 8. 2 Reinstalling the Thermal Air Guide Follow these steps to replace the thermal air guide back into the housing: 1. See section 2. 2 for more information on opening the housing panels. If there is an existing termination board installed in the CPU slot, remove it. Refer to section 3. 1. 4 for removing a termination board. 3-8 AcerAltos 21000 System Guide 4. Insert the Pentium II Xeon processor into an empty Slot 2 socket. OO 5. Carefully press down the Pentium II Xeon processor until it is properly inserted. Use the retention mechanism cover to secure the processor as shown below. The retention mechanism cover only fits one way. Both shafts of the retention mechanism and the retention mechanism cover have a O and a OO sign. Match the O on the cover with the O on the retention mechanism first, then hooked them together and then insert the OO side to the retention mechanism and make sure they are clipped. System Boards 3-9 7. Connect the heatsink cables to the main board. Refer to section 3. 1. 2 for the location of the thermal and fan connectors. Refer to the VRM LED guide (section 3. 1. 5) for installing VRMs. A VRM LED with green light indicates that a VRM has to be installed in its socket. 3. 1. 4 Installing and Removing the Termination Board When you are not using all the Slot 2 sockets, you must install a termination board into each empty slot. [. . . ] · · · · · Monitor system status (H/W and OS) after OS is up. Recover critical event by "smart reboot" (works with RDM). Record all events into file (NVRAM - H/W specific events). Integrate with 3 party management software. [. . . ]