User manual ACER IDM2 Install Guide

[. . . ] The product may fall, causing serious damage to the product. Slots and openings in the cabinet and the back or bottom are provided for ventilation; to ensure reliable operation of the product and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. [. . . ] Replace battery with the same type as the product's battery we recommend. Use of another battery may present a risk of fire or explosion. Refer battery replacement to a qualified serviceman. Battery may explode if not handled properly. Do not recharge, disassemble or dispose of in fire. Keep away from children and dispose of used battery promptly. iv Installation Guide 16. Use only the proper type of power supply cord set (provided in your keyboard/manual accessories box) for this unit. It should be a detachable type: UL listed/CSA certified, type SVT/SJT, rated 6A 125V minimum, VDE approved or its equivalent. Maximum length is 15 feet (4. 6 meters). IDM Housing v )&&&ODVV%5DGLR)UHTXHQF\ , QWHUIHUHQFH6WDWHPHQW Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Attach the drive guides on the sides of a 5. 25-inch drive with two screws on each side. 2. 3. 8 Installation Guide 4. Insert the drive into the drive bay and secure it with two screws. 5. Connect the signal and power cables to the drive. 5. 3 Hot-Swap Cage The hot-swap cage box includes the following components: · · · · One hot-swap cage (with back plane board attached) Three hard disk drive tray One system board connector cable Two Hard disk drive fault LED connector cable To install the hot-swap cage into the housing: 1. Open the front panel and remove the left panel of the housing. See section 4 for more information on opening the housing panels. IDM Housing 9 2. Attach the drive guides on the sides of screws on each side. the hot-swap cage with two 3. Insert the hot-swap cage into the housing and secure the hot-swap cage with two screws. 10 Installation Guide 4. Attach the power cable, the SCSI terminator, the HDD fault LED cable, and the system board connector cable to the backplane board and attach the other end of the connector cable to the system board. [. . . ]