User manual ACER P1203PB

[. . . ] Use the attached PS/2 adapter cable, USB adapter cable and RGB cable with this equipment so as to keep interference within the limit of a FCC Class B device. DO NOT LOOK DIRECTLY INTO THE LENS WHEN PROJECTOR IS IN THE POWER ON MODE. When using the projector in Europe COMPLIANCE NOTICE This Projector complies with the requirements of the EC Directive 89/336/EEC "EMC Directive" and 73/23/ EEC "Low Voltage Directive" as amended by Directive 93/68/EEC. The electro-magnetic susceptibility has been chosen at a level that gains proper operation in residential areas, on business and light industrial premises and on small-scale enterprises, inside as well as outside of the buildings. [. . . ] Adjusts the color balance in each color of the image. The color balance of the image shifts green as the number increases and shifts to purple as the number decreases. (Available only when VIDEO is selected as the source. ) · TINT cannot be adjusted when a TV50 (PAL or SECAM) signal is being displayed. Adjusts the color intensity of the image. (Available only when VIDEO is selected as the source. ) SHARPNESS . . . . . . The image sharpness rises as the number increases. Select ON to boot up the projector automatically by opt. turning on an externally connected power switch such as TV60 a breaker even when the main power switch of the INSTALLATION projector is off. Use this setting when the projector is AUTO POWER hanging from the ceiling. OFF ON · The projector will be in the stand-by mode when the AUTO POWER OFF OFF lamp is off. Use the remote control to turn on the SPLASH lamp. Use to avoid image noise such as wide stripes. Use to synchronize the projector with PC input signals so that the image is not blurred. This will be set automatically to match the input signal to component video (YCBCR/YPBPR) or RGB. Select ON when playing DVD discs containing data of widescreen images. Adjusts the image when flagging occurs near the top of the screen. opt. XGA60 SIGNAL HORIZ. POSITION VERT. POSITION TRACKING FINE SYNC RGB RGB 0 0 0 0 RGB OFF ON OK COMPUTER INPUT ANAMORPHIC HOLD USER 5 SIGNAL - USER (Normally, there is no need for adjustments. ) CLAMP POSITION/ CLAMP WIDTH . . . . . . . . . If you use something similar, the brighter colors of the projected image may become blurred. In this case, adjust CLAMP POSITION or CLAMP WIDTH. Use to adjust the image when its motion does not run smoothly. Use to adjust the image when the noise etc. Use to adjust the image when the noise etc. Use to adjust the image when the noise etc. [. . . ] If the command is not received correctly, the projector will not send the return command. (3) The personal computer checks the command and confirms if the command which has been sent has been executed or not. (4) This projector sends various codes other than the return code. When having a control sequence by RS232C, reject other codes from personal computer side. [. . . ]