User manual ACER TRAVELMATE P253-E

[. . . ] Should the programs prove defective following their purchase, the buyer (and not this company, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. Further, Acer Computer GmbH, reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or change. All brand and product names mentioned in this manual are trademarks and/or registered trademarks of their respective holders. Table of Contents I Safety Instruction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 II Product Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] c) When music is playing, short press "MODE" to main menu. d) When music is playing, short press "ESC" to return to music list interface. 4) Pause the music When music is playing, short press "ENTER" to pause the current music. Push "ENTER" button again and it will continue to play. 5) Adjust the sound volume Whenever music is playing or paused, " "or" "can adjust the sound volume. 6) Playing modes This player has equipped 5 music playing modes (Normal, Repeat One, Repeat Folder, random, Intro) Normal: Play music in a normal order, that is playing the first music file till the last. The symbol is 8 Repeat One: Repeat one song and the symbol is Repeat Folder: Repeat all the songs in music file and the symbol is Random: Play music at random and the symbol is Intro: Play the first 10 seconds period of all the songs orderly and its symbol is 7) A-B replay When music is playing, press "A-B" button once to determine the beginning of the period you want to repeat, see Pic 9; Press "A-B" again to specify the end of the section, see Pic 10. Then this period of the music will be repeated over and over. One more press "A-B" will end the repetition. Pic 9 Pic 10 8) Sound effect: The player has built in 8 sound effect, namely Normal, Rock, Jazz, Classical, Pop, 3D sound, Bass and User EQ. Sound effect can be set under Mode Music Equalizer. 9) Lyrics Synchronization If a *. MP3 file and a *. LRC file of the same music are copied into the player, the lyrics will show the same time when the music is playing. Playing Modes : This interface contains 5 options, namely Normal, Repeat One, Repeat Folder, random, and Intro. Press " "or" " to choose any of the five and press "ENTER" for confirmation. This is to set Repeat playing modes of songs. Sound Effect: This setting obtains 8 sound effects, namely Normal, Rock, Jazz, Classical, Pop, 3D Sound, Bass, and User EQ. Press " "or" "to choose the desired sound effect and press "ENTER" for confirmation. 9. 2 Recording Setup Four options will show up after entering the Recording Setup directory, namely "Record Mode", "Input Source", "VAD" and "Line in Sync". Press " "or" " to choose the desired one and press "ENTER" to the detailed setup interface. Record Mode: Under this interface, there are 3 options, namely Long time, High-quality and Music. Press " "or" "to choose the wanted mode and press "ENTER" for confirmation. Longtime record: this option can help get a longer time recording yet with a caporal quality. High-quality record: this option can get high-quality record yet has a shorter recording time. [. . . ] 11. 1 Install software Put the accessory installing disk into CD-ROM of a computer and it will automatically work and click the install button of the conversion tool and follow the clues by clicking "Next Step" to finish its installation. 15 11. 2 Run software Click [Start], then [System], and choose "ACV Transcoder". The interface of "ACV Transcoder. exe"looks as follows. Input File: The video file that needs conversion and its path Output File : The video file that has finished conversion and its storage path. Start Pos: Setting the starting point of the video file that will be played or converted. End Pos: Set the ending point of the video file that will be played or converted. [. . . ]