User manual ACER V273H

[. . . ] It can be displayed up to three (3) times. Make sure to adjust the resolution of your PC before reaching the maximum count. Note The resolution displayed on the screen is the optimal resolution for this product. Adjust your PC resolution so that it is the same as the optimal resolution for this product. Introduction Front MENU button [MENU/ ] Opens the on-screen menu and exits from the menu. [. . . ] (Refer to the Preset Timing Modes) If the initial screen (the login screen) does not appear, contact the Service Center or your dealer. Q: Can you see "Not Optimum Mode", "Recommended Mode 1680 x 1050 60 Hz" on the screen? Troubleshooting A: A: A: You can see this message when the signal from the video card exceeds the maximum resolution and frequency that the monitor can handle properly. Q: The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by referring to the OSD. The screen is out of focus or OSD cannot be adjusted. Q: A: Have you adjusted the resolution or frequency on the monitor?Adjust the resolution and frequency of the video card. (Refer to the Preset Timing Modes). LED is blinking but no images on the screen. Q: A: Is the frequency properly adjusted when checking the Display Timing on the menu?Adjust the frequency properly by referring to the video card manual and the Preset Timing Modes. (The maximum frequency per resolution may differ from product to product. ) There are only 16 colors shown on the screen. The screen colors have changed after changing the video card. Q: A: Have the Windows colors been set properly?Windows XP : Set the resolution at the Control Panel Appearance and Themes Display Settings. A: Windows ME/2000 : Set the resolution at the Control Panel Display Settings. The frequency can be changed by reconfiguring the video card. Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details. ) How can I adjusts the resolution?Windows XP: Set the resolution in the Control Panel Appearance and Themes Display Settings. A: Windows ME/2000: Set the resolution in the Control Panel Display Settings. * Contact the video card manufacturer for details. Q: A: How can I set the Power Saving function?Windows XP: Set the resolution in the Control Panel Appearance and Themes Display Screen Saver. Set the function in the BIOS-SETUP of the computer. (Refer to the Windows / Computer Manual). A: Windows ME/2000: Set the resolution at the Control Panel Display Screen Saver. [. . . ] Reboot the computer after installing the program for the first time. If a copy of the program is already installed, remove it, reboot the computer, and then install the program again. You need to reboot the computer for it to operate normally after installing or removing the program. Note Visit the MagicTuneTM website and download the installation software for MagicTuneTM MAC. When I run [My Computer-USB Video device] while the WCC is running, my computer turns off. Q: A: This can occur when two or more camera functions are operating. [. . . ]