User manual ACER VERITON S2611G

[. . . ] There should be at least 2 inches (5 cm) of clear space on all sides of the switch. 1 2 • Well ventilated (especially if it is in a closet). Note: Neither the GS605 nor GS608 are designed to be stacked on top of other GS605 or GS608 switches. [. . . ] Also, you’ll need one Enhanced Category 5 (Cat 5e) Ethernet cable with RJ-45 connectors for each device you want to connect to the switch. Each Ethernet cable must be less than 328 feet (100 meters). Note: If you have more than 5 or 8 devices to connect to this switch, you must connect them to a hub or other switch and then connect that hub or switch to this switch. See the note about placing several switches near each other in section 2. Connect the power adapter’s cord into the back of the switch and then plug the adapter into a power source (such as a wall socket or power strip). The corresponding port number for each connected and powered device should light when link (connection), and flash when activity occurs. 3 Install the Switch and Connect the Other Devices Troubleshooting The Power light is not lit The switch has no power. € • Make sure the power cord is properly connected to the switch. Make sure the power adapter is properly connected to a functioning power outlet. Network Interface: DC Power: Physical Dimensions (h x w x d): Weight: Operating Temperature: Electromagnetic Compliance: Safety Agency Approvals for the Power Adapter: Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference. € This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. € Increase the separation between the equipment and receiver. [. . . ] € Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. € Consult the dealer or an experienced radio/TV technician for help. Performance Specifications Frame Filter Rate: Frame Forward Rate: Network Latency: (using 64-byte packets) Address Database Size: Addressing: Packet Buffer Memory: 14, 800 frames/sec max for 10M port/148, 800 frames/sec max for 100M port/1, 488, 000 frames/sec max for 1000M port 14, 800 frames/sec max for 10M port / 148, 800 frames/sec max for 100M port/1, 488, 000 frames/sec max for 1000M port 1000 Mbps to 1000 Mbps: 20 µs max 4000 MAC addresses 48-bit MAC address 1 Mb EN 55 022 Declaration of Conformance This is to certify that the ACER Model GS605/608 Gigabit Ethernet Switch is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. [. . . ]