User manual ACER VERITON X2611

[. . . ] Record the model number, serial number, purchase date, and place of purchase information in the space provided below. The serial number and model number are recorded on the label affixed to your computer. All correspondense concerning your unit should include the serial number, model number, and purchase information. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopy, recording, or otherwise, without the prior written permission of Acer Incorporated. AcerPower 8600 Quick Guide Model Number Serial Number Purchase Date :_________________________________ :_________________________________ : _________________________________ Place of Purchase : _________________________________ All trademarks, registered trademarks and/or service marks are the properties of their respective owners. Ap8600qg. book Page iii Tuesday, November 9, 1999 4:10 PM iii Table of Contents Notices . [. . . ] Replace only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af samme fabrikat og type. Léver det brugte batteri tilbage til leverandøren. ADVARSEL Eksplosjonsfare ved feilaktig skifte av batteri. Benytt samme batteritype eller en tilsvarende type anbefalt av apparatfabrikanten. Brukte batterier kasseres i henhold til fabrikantens instruksjoner. VARNING Explosionsfara vid felaktigt batteribyte. Anvãnd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera anvãnt batteri enligt fabrikantens instruktion. Do not remove a component from its protective packaging until you are ready to install it. Wear a wrist grounding strap and attach it to a metal part of the system unit before handling components. If a wrist strap is not available, maintain contact with the system unit throughout any procedure requiring ESD protection. Preinstallation Instructions Always observe the following before you install a system component: 1. Turn off the system power and all the peripherals connected to the unit before opening it. Open the system according to the instructions on page 15. Follow the ESD precautions on page 13 before handling a system component. Remove any expansion boards or peripherals that block access to the RIMM sockets or CPU connector. See the following sections for specific instructions on the component you wish to install. Ap8600qg. book Page 14 Tuesday, November 9, 1999 4:10 PM 14 Warning!Not turning off the system properly before you start installing the components may damage your system. Do not attempt the procedures described in the following sections unless you are a qualified service technician. Post-installation Instructions Observe the following after installing a system component: 1. See to it that the components are installed according to the step-by-step instructions in their respective sections. [. . . ] Make sure that the card is properly seated. Ap8600qg. book Page 22 Tuesday, November 9, 1999 4:10 PM 22 5. 6. Secure the card to the housing with a screw. Reinstall the housing cover (see page 16). When you turn on the system, BIOS automatically detects and assigns resources to the AGP devices. Removing a AGP Card To remove a AGP card, simply reverse the instructions listed under the "Installing a AGP Card" section. Ap8600qg. book Page 23 Tuesday, November 9, 1999 4:10 PM 23 Board Layout Your system board should look just like the following figure: The following table lists the components that you will find on the system board: No. 1 2 3 4 5 6 7 8 Component USB ports PS/2 keyboard port Serial port 1 Parallel port Serial port 2 Game/Midi port Speaker-out/Line-out port Line-in port Ap8600qg. book Page 24 Tuesday, November 9, 1999 4:10 PM 24 No. [. . . ]