User manual ACER X1270

[. . . ] Use the attached RGB cable, RS-232C cable with this equipment so as to keep interference within the limit of a FCC Class A device. The projector automatically shuts off when the lamp is used up in about 2, 000 hours and cannot be used until the lamp is replaced and the internal timer is reset. DO NOT LOOK DIRECTLY INTO THE LENS WHEN PROJECTOR IS IN THE POWER ON MODE. When using the projector in Europe COMPLIANCE NOTICE This LCD - Video Projector complies with the requirements of the EC Directive 89/336/EEC "EMC Directive" as amended by Directive 93/68/EEC and 73/23/EEC "Low Voltage Directive" as amended by Directive 93/68/EEC. [. . . ] Use to display the splash screen on the screen when the power is turned ON. IMAGE REVERSE Use to reverse or invert the projected image. MIRROR, INVERT is for rear projection ceiling mount. Opt ON 3 FEATURE MENU POSITION . Use to select the position where the menu is displayed, (upper left) or (lower right). When AUTO is set, the appropriate video format is FRAME POSI. automatically selected according to the input signal. VIDEO SIGNAL image does not appear correctly, select the desired video ANAMORPHIC format manually. Set ON when displaying DVD discs which are recorded in RESET ALL letter boxed images. Use to select the language for the projector display such as menu. ( / English / Español / Deutsch / Français / Italiano / ) RESET ALL . . . . . . . . Use to reset the MENU setting (except LANGUAGE). Opt A A A XGA60 1. Press the $ or % button to select the memory which you wish to record (USER 1 or USER 2). Initialite the setting which has been changed (Default) Select RESET in the SIGNAL menu, and press the ENTER button. · When initializing, selection buttons will not work for about 2 - 18 seconds. Select the user setting Select MEMORY CALL in SIGNAL menu, and press the $ or % button to select the memory (USER 1 or USER 2). Select DELETE in the SIGNAL menu, and press the ENTER button. Press the $ or % button to select the memory which you wish to reset (USER 1 or USER 2). The recorded setting will be reset. EN ­ 17 ENGLISH Picture adjustment Adjusting the image You can adjust the picture by using the IMAGE menu. Opt 5. Press the $ or % button to adjust the color balance of the color. Repeat steps 4 and 5 for more adjustments. Exit the menu system by pressing the MENU button several times. · When using the setting which has been already prepared, select desired position 1 or 2 in step 3. [. . . ] (3) The personal computer checks the command and confirms if the command which has been sent has been executed or not. (4) This projector sends various codes other than the return code. When having a control sequence by RS232C, reject other codes from personal computer side. · * : The sending time of return command maybe delayed depending on the condition (during changing the input signal, etc. ). [Example] Turn the power ON (' 'is for ASCII code) Sending commands from the PC etc. [. . . ]