User manual ACESONIC POCKET KARAOKE DATASHEET

[. . . ] · If you will not be using the system for an extended period of time, disconnect all power sources. Remove the batteries from microphones. Receiver Description (Front) 1 Power switch / IR Sync 2 Channel A volume control 3 Channel A selector 4 Display panel 5 IR Sync sensor 6 Channel B selector 7 Channel B volume control Receiver Description (Back) 1 Channel B antenna connection 2 12V AC power connection 3 Channels A & B XLR balanced audio output 4 Channels A & B 1/4" unbalanced audio output 5 Channel A antenna connection 2 Microphone Description 1 Microphone cartridge 2 Transmission antenna 3 Operating indicator light (Green means power is on & working, yellow means power is on & muted. ) 4 On/Mute button 5 Battery compartment: This is the base of the microphone where you would hold it, as well as the device's battery cover. 6 IR signal receiving & charging unit. How to IR Sync · Make sure microphone is On. · Select a desired channel on the receiver. [. . . ] With your thumb and forefinger, go over the curved grips, pull the gate open and out. It should pivot on its hinge at the lower end. · Place two AA Ni-Mh rechargeable batteries into the battery compartment spaces provided. Press the batteries firmly to make sure that they have clicked into place. Screw the battery housing cover back on. Using the charging station: · Plug the AC power adapter cord jack into the matching power socket on the rear of the charging station. Plug the AC adapter into an AC outlet. 3 · Stand the microphones upright into the station's dual base charging station. Each status LED on the charging station will light up RED to indicate a good connection and that the batteries are charging. Allow the batteries to charge fully before removing the microphones from the charging station. · When system is not in use, unplug the receiver from the wall socket and remove the power adapter from the rear panel. · If a microphone won't be used for an extended period of time or putting it in storage, remove the batteries to prevent corrosion. Cable Connections & Operating the Microphone System · Unpack the box. amplifier, mixer or player If you have a corded microphone, test your amplifier/player to make sure that it's operating correctly. _________________________________________________________________________________________ Not Syncing · Microphone batteries are low or turned Off · Make sure batteries are fully charged and turned On · Install antennas as instructed · Receiver antennas not installed properly · Microphone not positioned properly · Make sure bottom of microphone is facing the IR sensor for syncing _________________________________________________________________________________________ · Too close to speakers Sound · Move away from speakers (distortion or feedback) · Microphone batteries are running low · Change batteries · Unused microphones are on · Turn off or turn down volume of all unused microphones · Other electrical interference · Move receiver away from other devices Safety, warnings and cautions Mises en garde, precautions et procedures de sûreté The exclamation point within a triangle alerts the user to important operating, maintenance, and servicing information in this User Manual. CAUTION To reduce the risk of electrical shocks, fire, and possible injuries, you should not · remove screws, buttons, antennae, jacks, or any part of the enclosure; or · expose the product to rain or moisture. 6 The lightning-with-arrowhead symbol inside a triangle alerts the user that potentially dangerous voltage in the product enclosure may constitute a risk of electric shock. FCC ADVISORY (U. S. A. ) 1. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correcting the problem by one or more of the following measures: · Reorienting and/or relocating the receiving antennae · Increasing the distance between the radio/TV equipment and the POCKET KARAOKE · Connecting the radio/TV equipment to an outlet on a different circuit than the one into which the receiver is plugged · If necessary, consulting the dealer or an experienced radio/TV technician for help 2. IMPORTANT: When connecting the POCKET KARAOKE to audio equipment, use only high-quality, shielded cables such as what is supplied with this product. Follow all installation instructions do not modify the equipment in any way, as this could void your FCC authorization to use the device in the U. S. FOR CANADA/POUR LE CANADA Caution: To prevent electric shock, match the wide blade of the plug to the wide slot, and fully insert. [. . . ] Maintain sufficient room on all sides for airflow. Do not position the device on or near radiators, stoves, or other electrical equipment (such as amplifiers) that produce heat. Do not defeat the safety purpose of a polarized or grounding-type plug. A polarized plug has two blades with one wider than the other, while a grounding-type plug has two blades and one prong. [. . . ]