User manual ACT ACT10 DIGITAL KEYPAD

[. . . ] Exit Programming Mode. INSTALLATION NOTES 3. Change Programming Code. Press X button followed by the programming code (9999) The yellow indicator should be flashing 2. Enter Programming Mode. 30 SECOND PROGRAMMING GUIDE (for typical system) Press 0, then 1 followed by the new user 1 code (four digits) The keypad is now ready for normal use. The yellow LED should stop flashing. IMPORTANT ACT10 DIGITAL KEYPAD Downloaded from: http://www. guardianalarms. net KEYPAD OPTIONS 30. [. . . ] Six Digit Codes When set, all user codes and the programming codes are six digits long. The default user one code becomes 123456 and the default programmer code becomes 999999. Twin Codes When set, two different codes must be entered within 15 seconds in order to open the door. The outputs activated are those which have been programmed for the first code to be entered. Door Forced Alarm When set, the buzzer output is activated if the door contact opens when a valid code has not been entered. The output is deactivated when a valid code is next entered. This is useful for monitoring fire doors etc. Group Disable When set, the top five user codes (5-9) are inactive any time the interlock input is activated. This restricts access to certain codes under external control (i. e. an alarm system output or a time clock). Auto Backlighting When set, the keypad illumination is normally off, but will switch on in response to any key being pressed or while in programming mode. This option is overridden by option 32 (permanent backilghting). To prevent any illumination, unset options 32 and 42. Door Ajar Alarm When set, and the door contact has been open for longer than the time programmed into the door ajar timer, the built­in and external buzzers sound intermittently. The buzzers may be silenced by closing the door and entering a valid code. Guest Button When set, (default) and when the # key on the keypad is pressed, the buzzer output is activated for the duration programmed in the guest buzzer timer. Fire Alarm Override When set, the relay is held active whenever the interlock input is active, and the green indicator will flash. This is useful for following a fire alarm system to override controlled doors. [. . . ] Restore power and proceed with programming. Note: The keypad will not operate correctly without LK1 in place. Typical ACT10 Configuration (Normally de-energised lock shown) Power up without link if Progr amming code has been lost. +V 0V 12-24 AC/DC Power Supply 12-24V ACDC Door Release Button LK1 + N/C C N/O OMR ON 5A 2 5 0A C V 5 A 3 0 V DC OMR ON 52 5 0 V A C A 5 3 0 V DC A Door Contact 0V Interlock (PB2) Push Button Door Contact OUTPUTS INPUTS 0V Buzzer OP3 Duress OP2 Interlock TAMPER Batch: 20xx-1 Product:ACT10 Rev3. 0 Serial No. Always Place Varistor Across All Lock Terminals +V Guest Buzzer 0123456789 N/C C N/O Volt - Free Tamper Contacts Door Release Button for Door 2 This diagram shows revision (3. 1) of the ACT10 This unit may be used to control 2 doors as illustrated in the diagram above. Connections and programming for this unit are exactly the same as for previous versions, however the connector positions have changed as shown in the above diagram. Unit 8 IDA Business Park, Whitestown, Tallaght, Dublin 24, Ireland. [. . . ]