User manual ACT ENTRY V-IP

[. . . ] ACTentry V-IP Operating & Installation Instructions 18-00068 This manual refers to ACTentry V-IP, a TCP/IP based door videophone system. reserve the right to change the contents of this manual and the system it applies to without prior notice. While every effort has been taken by ACT to ensure the accuracy of the information contained within this document, ACT assumes no responsibility for any errors or omissions. No liability is assumed for damages resulting from the use of information contained within this document. Access Control Technology Unit C1, South City Business Centre, Tallaght, Dublin 24, Ireland. [. . . ] (A fixed IP address may also be assigned, see section 5. 0). The LED's on the PCB indicate the status of the connection to the network. When both LEDs flash momentarily every couple of seconds, the unit is powered but not connected to the network. When the green LINK LED is turned on, the ACTentry V-IP is connected to the network. The red TX/RX LED indicates data transmission between the network and the device. Page 7 Issue 3 · ACTentry V-IP Operating and Installation Manual 2. 5 ACT handset and PC speaker connection 1. The ACT Handset and PC speakers should be connected according to the diagram above. The PC speakers should be powered and switched on. The PC speakers jack plug (green) should be plugged into the ACT handset jack socket (green). The ACT handset microphone jack plug (pink/purple) into the PC soundcard Microphone socket usually symbolised by the following. . . Microphone 5. The ACT handset speaker jack plug (green) should be plugged into the PC soundcard Lineout or headset jack socket (green). These are usually symbolised by the following: Line Out Headset Page 8 Issue 3 ACTentry V-IP Operating and Installation Manual 2. 6 ACT handset mounting A handset holder is provided with the ACT handset. This should be mounted in a location that is both easily accessible for the user but not obstructive for the user (as shown below). Before attaching the holder, clean the mounting area with soap and water, (do NOT use any solvent) and let the area dry. Remove the foil from the adhesive tape and press the holder firmly against the mounting surface. Wait a few hours before hanging up the handset for maximum adhesion. A cable clamp is also provided for cable management. It is also possible to simply place the handset on the desk, without using the mounting holder. If the phone and cord are not impeded, the handset and its switch will function properly. 2. 7 ACTpro-X 1030 Panel-Mount reader installation ACTentry V-IP may be used in conjunction with an ACTpro access control system. Cardholders present their proximity cards to the panel mount reader to gain access. Visitors use the call button on the door panel. Please see the ACTpro-X 1030 panel mount installation diagram at end of this manual. Page 9 Issue 3 ACTentry V-IP Operating and Installation Manual 2. 8 ACTentry V-IP software installation The V-IP unit needs to be powered up and connected to the network before proceeding with the installation. ACTentry V-IP software is designed to operate on a PC connected to a TCP/IP network. [. . . ] To set the ip address enter: setip <ip address> <gateway> <subnetmask> Eg. setip 172. 27. 72. 63 172. 27. 72. 254 255. 255. 255. 0 6. IP address is now set to 172. 27. 72. 63 7. Type quit to exit. Page 20 Issue 3 ACTentry V-IP Operating and Installation Manual If the V-IP unit does not have a known IP address, then it can be set to a default value by doing the following: 1. [. . . ]