User manual ACT PRO 1000

[. . . ] QUICK PROGRAMMING GUIDE (for typical Standalone System) 1. 4. Changing Operator code. The controller will display Accepted , the new pin is set. [. . . ] Use numeric keys 0-9 to Enter the year . Repeat for month, day , hour and minute. Use X to exit from the menu. 6. 3. Entering a batch of cards onto controller. Press to allow the first card in the batch to be programmed. Enter the user number to be assigned to the first card . Use X to exit from the menu. Factory default code: ( Operator: 123456 ). Note: To Program the advanced features of the ACTpro 1000 / 2000 use the Operating Instructions which are available from the distributor. · · · Access Control Technology thank you for choosing its product. Please find below some useful notes to ensure satisfactory performance from your Access Control System. As with any access control system, always ensure that there is an alternate means of escape in the event of the unit failing to operate due to power loss or in the event of fire. Visit our website: www. accesscontrol. ie or www. act. eu Unit C1 South City Centre, Tallaght, Dublin 24, Ireland. Tel: +353 (0)1 466 2570 UK Lo-Call: 0845 300 5204 Copyright © 2009 Access Control Technology Ltd. (18-00008-00) Ensure that any lost cards are immediately deleted from the system. Ensure that any damaged user cards are replaced , by your Installer. Ensure that your staff are fully aware of the operation of readers and report any system problems to the Installer immediately . Good Housekeeping. IMPORTANT ACTpro 1000 / 2000 Access Control (Operator Instructions) Operator Menu 1 2 0 3 4 5 6 (This is the default code) 0 User Setup Group Setup System Log Control Door User Tracking Set Date/Time Time Zones Set Holidays Issue Number Change PIN 3 7 Operator Menu 3 0 Enable Disable Assign Names Assign Groups Assign Options Assign PINs Learn Batch Cards One-To-One Card Validity User 1 Disabled User 2 Disabled User 2 Enabled 1 User Setup Menu navigation in User & Group Setup functions When one of the user or group setup functions is invoked, the top line of the display will show the number of the group or user. If a text name has been entered, this will be shown instead. The lower line will show the current setting for the item that is being configured. Pressing the zero key will advance to the next user or group. Group Setup 0 7 0 7 Lock Door Unlock Door Normalise Door Pass Door Aux Output On Aux Output Off 0 7 *On the ACT2000 you will first be prompted to select which door to control. [. . . ] + ' / 9 0 Verify PIN Accepted or Verify PIN Not Allowed When the new PIN is entered, the controller prompts for the code to be verified to ensure that no mistakes have been made. Assuming all is OK, the controller will display "Accepted" - the new PIN is now set. User and Group PINs may be unset (removed) by entering a PIN consisting of all zeros. [. . . ]