User manual ADAMS RITE MS1881

[. . . ] Use only the right fuses with the same current rating and trigger characteristic as replacements. Pull the mains plug before replacing a fuse. Should a fuse blow again after a short while, the device needs to be checked. Never install your amp close to devices with strong electromagnetic fields such as large mains transformers, revolving machines, neon illumination etc. [. . . ] Input level control Bass control Treble control panorama control to distribute the effects between the channels. left: internal effect on channel 1 & external effect on channel 2 mid: internal & external effect on channel 1 and channel 2 right: internal effect on channel 2 & external effect on channel 1 push button for selection of four effects, indicated by the LEDs between return and master. level control for the internal effects This LED indicates that your amplifier is ready to use Adjusts the overall volume level bass middle treble select return power master 3 Back panel (from left to right): Compact 602 phones Output for a stereo headphone set. Never use mono jack plugs, otherwise the amp could be damaged! twin channel acoustic amplifier send return Output to the input of an external effects unit. Input for the output signals of an external effects processor. 6. 3 mm mono jack socket. tuner line out DI-out Output to an external tuner. 6. 3 mm mono jack socket. footswitch connection to a double footswitch to switch internal preamplifier output after the master control. (Tip = internal Effect, Ring = external Effect on/off ). Balanced preamp output, pre master, post EQ, with return and effects. XLR socket power on Combined power switch with fuse holder and IEC mains socket 4 4. Operation Summary · Cabling and startup Check if your local mains voltage (e. g. Furthermore an additional effects unit (external effect) may be connected. For this purpose please use the send and return sockets located on the back of the amplifier (send goes to Input, return is connected to the output of the external effects device). The intensity is then adjusted at the external effects unit. The external effects loop works in , parallel` mode, i. e. the effect signal is blended with the original signal. A standard double footswitch can be connected to the footswitch socket on the rear of the amp with a stereo cable. This switch can be used to turn the internal and external effects on and off. We wish you hours of happy playing with your Compact 602! 5 5. Technical Data Inputs Input (channel 1) Stereo jack ¼" (6. 35 mm) High impedance, unbalanced jack input for instruments (pick-ups) and line-level sources. high/low switch: ­10 dB attenuator Impedance: 2. 2 Meg Input (channel 2) Combo socket, XLR jack ¼" (6. 35 mm) line mode: High impedance, unbalanced jack input for instruments (pick-ups) and line-level sources. Sensitivity: 38 mV Impedance: 1 Meg mic mode: XLR (balanced), stereo jack (balanced), or mono jack (unbalanced) input. [. . . ] However, we are also happy to help in this case and we can present you with the options of where to dispose of these electrical goods. The telephone number of ADAMS RITE GmbH: +49 (0)2361 891789 Here, we will provide you with qualified information on the disposal of ADAMS RITE GmbH waste electrical and electronic equipment. European Union, Norway, Iceland and Lichtenstein The disposal of electronic equipment in household waste is not permitted. All ADAMS RITE electrical equipment affected by WEEE has been labelled with the symbol of a crossed out dustbin since 13. 08. 2005. This is also applicable for Norway, Iceland and Liechtenstein. [. . . ]