User manual ADCOM ACE-315

[. . . ] To reduce the risk of shock, do not expose this unit to rain or moisture. serial # WARNING: Equipment with high-current requirements, such as hobby arc-welders, hair dryers and heaters must not be plugged into these AC receptacles. Never allow total power consumption of all equipment connected to these outlets to exceed 1800 watts. 10 Timber Lane Marlboro, NJ 07746 USA Made in the USA power 120v 60Hz max 1800W AC Enhancer owner's manual SE T PRE Safety Instructions · Read all instructions and store them for future reference. [. . . ] After you have unpacked the ACE-315, inspect it for physical damage. Save the shipping carton and all packing materials, as they are intended to minimize the possibility of transportation damage, should the product ever need to be shipped again. In the unlikely event damage has occurred, notify your dealer immediately and request the name of the carrier so that a written claim to cover the damage can be initiated. The right to any claim against a public carrier can be forfeited if the carrier is not notified promptly in writing and if the shipping carton and packing materials are not Connections Optional: Attach the supplied color-coded AC cord labels to each AC cord to be installed. Place a label at each end of the AC cord to easily identify which cord is connected to each product. System AC Connections Begin by connecting products which require full-time AC power to the rear panel jacks labeled "unswitched" 1). Connect the remaining AC power cords to the rear panel "switched" AC outlets i, j. Symbol explanations Grounding Screw The grounding screw 1!provides a convenient system grounding point where one or more of the components is not equipped with a three prong AC cord. The entire system can be grounded by simply connecting a wire between the chassis of any system component and the ACE-315 grounding screw 1!. (The remaining components will be grounded to the ACE-315 through the various audio and video coax connections. ) NOTE: All outdoor cables must be properly grounded prior to entering a building. See the Safety Instructions section for further details. Operation The unswitched front panel LED d indicates that AC current is passing through the ACE-315 and into the components connected to the unswitched AC rear panel outlets 1). The unswitched LED d is always on provided the unit is plugged into an active AC source. Phone Line Connect the phone line from the wall outlet to the phone in jack e. Connect the phone out jack h to the line input of a modem, DVD, TiVo, DSS receiver, or pay-perview cable box. Front Panel Control Press the ACE-315 power button b to activate the unit. The power LED b and switched LED c will glow red. AC power is being supplied to all connected components. Remote Triggering The ACE-315 may be remotely activated and deactivated using a low voltage trigger signal available from most contemporary preamps and receivers. [. . . ] email and website info: info@adcom. com www. adcom. com Please include a return e-mail address for the reply. Please address all mail inquires to: ADCOM Service Corporation 10 Timber Lane Marlboro, NJ 07746 USA Please include a return address for the reply. Technical Specifications Electrical Input power. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120VAC, +/-10%, 5-/60Hz Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15A Circuit Breaker Internal Power Consumption. . . . . . . . . . . . . . . . . . . . . . . . . Less than 5 watts Control Input. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +/-5V to 24V AC/DC Total Output. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15A Environmental: Operating Temperature. . . . . . . . . . . . . . . 0 to +50 C Storage Temperature. . . . . . . . . . . . . . . -40 to +80 C Filter Noise: Normal Mode. . . . . . . . . . . . . . . . -5dB at 5kHz; -38 dB at 300kHz Common Mode. . . . . . . . -3dB at 300kHz; -40 dB at 1 MHz Surge Protection Endurance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1, 000 surges 6 kV; 3 kA Clamping. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 172 volts Response Time. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0sec (Passive protection / always on) Maximum Applied Pulse (Combination Wave): · Voltage: 6, 000 volts · Current: Unlimited due to current limiting · Joules: Unlimited due to current limiting Mechanical Dimensions. . . . 17"(430mm) x 5-15/16" (150mm) x 3. 5"(89mm) Weight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 lbs (2. 7 kg) AC Cord. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ft (1. 8m) -Unit may be in standby mode -Remove any plug in the 12v trigger jack Typical Connections to device from wall out coax in max 1800W bank 2 switched bank 1 unswitched (always on) in from preamp CIRC Surge Protector and AC Enhancer model ACE-315 voltage: 120V AC/60Hz, internal power consumption: 10w max 12v trigger UIT BREA S S TO R E phone out in GND WARNING: For indoor use in dry locations only. [. . . ]